post the tune.... i got my 5.4 procharged on LPG and water meth dialed in so im pretty familiar with the procharged setup
Type: Posts; User: trunks604
post the tune.... i got my 5.4 procharged on LPG and water meth dialed in so im pretty familiar with the procharged setup
you can turn it off through the car menu under vehicle settings
hey does anyone know how to read knock counts instead of voltage? Or does anyone understand knock sensor voltage ? Just trying to figure out how much or if iam getting knock or not.
2005 ford...
fully tuned on propane and water meth 10 psi afr 14.4 490 cold and 480 hot
yeah this one got me very puzzled for over a month....
the tunes are completely different
between the 4.6 and the 5.4
i just noticed its a 4.6
i have one for the 5.4
I have the same truck ... everytime I touched the maf settings i had the same error... it seems that the truck doesnt like the maf settings touched at all.
i have a pretty good tune for this truck if your interested ... 91 octane tune.....
all fixed ... stupid injectors were not 39# they are actually 39.5# prochargers instructions were wrong
ok so I found out the instructions that came with the procharger kit says that the injectors are 39# injectors... When I use the codes nothing works properly on the truck. I did a little bit more...
ok .. I will try it again and dial the maf to trim it in ... Thanks keep you posted on it
Oh ... Sorry lets try this again LOL .. The truck is a 2005 Ford f150 5.4 Procharged 10 psi, water meth, Propane VSI mostly on propane. I installed bigger injectors on the fuel side. After I...
I work on lots of these engines and even stock it happens in number 8 ... ive seen the piston in the bottom of the pan. Ford will warranty this as defective.
ok ... so i corrected all the values properly to the decimal point.. after this i need to adjust the mass air flow ?
So I got the ford 39# blue injectors
entered all the data from this link https://fordperformanceracingparts.com/parts/ics/m-9593-m39.pdf
So I get all the code for the injector and enter them all in.. start up the truck and my stft is 18? Am I missing something here ?
sorry this the injector number I got off the injector 2r3v-b5a ... maybe the data sheet i got is not right for this ?
I used all the new data for the 39# injectors and after the update the truck runs super lean at idle ... did i miss out on something
54025
how about the FNPW_BKCOMP settings ... do i need to do this ? the psi chart doesnt match with the one on the hpt ?
oh that helps alot ... information I have is all wrong !
Someone gave me this but i dont think that its right
Flow rate low 39.01294 lb/hr
Flow rate high 32.24041 lb/hr
breakpoint 0.00001400
pw minium 0.40054 msec
Hey guys does anyone know that code for ford 39# injectors ? ... any info would help
thanks
ok i got the truck to run really good on propane .... im still having problems with wot surging in gas mode.. almost feels like a maf issue... anytime I make changes to the maf it bucks and dies...
sorry still new at this