Correct.
Type: Posts; User: swissgtp
Correct.
I think you have to load the tune with flex fuel enabled on first and then fill it up. As soon as the PCM dedects a change of the fuel level it will calculate the afr based on the input of the oxygen...
I've added the following numbers to all of the rows from 0 to 43200 in the cranking fuel table and it helped a lot:
-40 0.750
-22 1.101
-4 1.300
14 1.601
32 1.700
50 0.601
68 0.250
I tried it on my 08 STS Northstar and set the switch to enable and filled up with E85. The AFR adjusted correctly and the engine run fine but then I dedected rough shifting. Looking at the scanner I...
Laz, many thanks! I'm confident that this really helps. Much appreciate your efforts. I will try out the new configuration next week as soon as I have my car back. Before going to the expensive Euro...
Thank's very much! I just found out that the engine is at ambient temperature which must be around 70 F or higher.
I don't know if it is of any help, I attached a scan of a cold start up of the car...
Ambient temperature was 70 F - engine was at ambient temperature (according to description of test procedure)
The drive cycle starts with a cold start of the engine, than 11 sec idle before driving...
My US-spec 08 Cadillac STS4 4.6 V8 has to pass Euro 4 emmission certification before I can homologate it in Switzerland.
It didn't pass the first test, CO and HC were too high, NOx was ok:
HC...
I have excatly the same car, never experienced that on mine.
But I remember seeing that on rental cars like Chrysler 300 C or Buick LeSabre...
If you don't see the drop in your HUD or Scanner,...
Which of the timing tables affect timing on startup?
I'm running on E85 and would like to set higher timing on startup.
Zurich, Switzerland