The VCT mapped points are the Ex/In positions the Ghost cam uses when not in OP (full throttle). These are found in Engine: Airflow --> VCT --> Intake Valve Closing and Exhaust Valve Closing. The...
Type: Posts; User: bravo685
The VCT mapped points are the Ex/In positions the Ghost cam uses when not in OP (full throttle). These are found in Engine: Airflow --> VCT --> Intake Valve Closing and Exhaust Valve Closing. The...
The minimum VSS value is key to the whole setup. If it's anything other than Zero the cams will be parked at idle. Your check light is most likely due to the load value being off as load is...
Anyone have the Ford Procal and performed the crank sensor relearn procedure (P0315)? Can you tell me how long the operation takes. Is this an engine running test.
Rob
Here is a *.pdf of the screen shots of the tables needed to keep the cams from parking after a few seconds at idle. Keep in mind that you will still need to do the speed density tune to keep the...
You need to set your Mapped Points -> Intake and Exhaust Closing points at the 0 and 1 positions for idle.
Set your VCT Optimum Power Pedal Position to 30.0 at and near idle
Set your VCT Optimum...
Absolutely, I don't mind at all. I have been playing with the cam position changing how aggressive it sounds. Doing so changes the speed density calc. so I am working on getting this cleaned up.
...
The table itself is correct it's the Y axis in the table that will not allow you to change it above it's max value - which is 2.0 or 8.0. Reading the file out you see the rpm for the row but...
In the Copperhead 2048K pcm
Under Engine -> Idle:
Dashpot Preposition vs. RPM
&
Dashpot Minimum (4th, NoDecel) vs. Desired Idle RPM.
Both tables axis Maximum values are to low.
It's a manual. I believe I have it sorted now just fine tuning the cold start up and off throttle settings now.
Use the MAF Airflow vs. Period table for tuning. Yes the table is upside down. Just pay attention to the right side column marked AIRFLOW. It's in #/min and on a stock vehicle ranges from 0 - 68.
...
2013/2014 Mustang (possibly 2012 and under).
I see you have the 'O2 Sensor Closed Loop Bias' but we could use the 'Closed Loop 02 Feed Forward Bias' tables also to trim the O2 stoich point at...
Has anyone tried adjusting their cam position while not in Optimum Power. Meaning changed the Intake and Exhaust Mapped points. Or have a 2013/14 with a lumpy cam idle?
What i'm running into is I...
The value is in percent and should be used as a decimal value.
4% = 0.04
30% = 0.3
I'm not able to uninstall the current beta (downloaded 4/9/14 9PM EST).
Using Add/Remove Programs only removes the name listed in Add/Remove. The application folder and executable are still in...