Have truck idling, disabled things like DFCO, COT, Flex fuel, STFT and LTFT. I followed instructions on setting up to run SD and disable MAF but puts my truck into limp mode. Leaving MAF on and...
Type: Posts; User: [email protected]
Have truck idling, disabled things like DFCO, COT, Flex fuel, STFT and LTFT. I followed instructions on setting up to run SD and disable MAF but puts my truck into limp mode. Leaving MAF on and...
126722
126723
Reverted back to tune that it drove on before. It does run better, noticed MAP was running around 80-83kpa still but less than before. Didnt lose throttle however. Didnt have chance...
Swapped gm sensor back in. Reset fuel trims and any codes etc. started up and idles 6-700 right around 98kpa. Light tap to throttle to rev to about 1500-2000 and saw 42kpa. Released to allow to...
Blindsquirrel- I?ll have to check into that and get back to the thread with more info.
Rdf1- I?m running factory one from the donor 04 Yukon at the moment. Thoughts on this? I appreciate the...
That is valucraft brand to replace 09359409.
I understand you want me to clear long term fuel trims. It is unclear other than perhaps replace with another map sensor what you?re advising. I do...
Su1078vc
In hopes this helps and someone can assist here are the latest files in reference to last posting.
126714
126715
As stated in last post I now went other direction. I have disabled MAF and Closed Loop to trigger Open loop full time to tune in VE table. My latest issue i have come into is that when i backed truck...
Update:
Found my crankshaft position sensor wiring needed repair, also replaced map sensor. Wanted to share my latest run and edit. When starting my truck it idles a little rough and then revs on...
Made edits and disabled unnecessary things. Here is latest idle file.
126353
Still set code for MAF and MAP and checking pins and wiring now before getting next data. Also set po200 again....
Forgive my ignorance but I did go into file last night to remove codes for o2 sensor 2 related items to mark as no error reported. But they were all greyed out and wouldn’t allow me to take check off...
Thank you, this is all great information I either overlooked or didn’t understand completely. You’re right in that I have no disabled things not brought over. I am in fact using Yukon map and maf...
Good catch. I will disable this. Flex fuel tab if I remember correct and right?
List of codes that set are as follows:
P0068 Map/Maf - throttle position correlation
P0101 Mass or volume air...
2004 gmc yukon 5.3 swapped into 98 dodge ram 1500. Has sloppy stage 2 cam and springs, also gen4 6.0 rods and 4.8 pistons. Attached is my first second and last log i took last night and attempted...