Thought about re-flash but a reset button that works would be allot simpler :)
Type: Posts; User: gtautoparts
Thought about re-flash but a reset button that works would be allot simpler :)
Any thing ever come out for this? I got a 08 Tahoe in the shop that is stuck on 75% methanol. Would be cool if the reset button in the scanner worked
I have had the min vss set to 55 mph on my 2010 since about 2 weeks after I got it in 09 and it works great. I never here it with long tube headers, high flow cats & fairly loud exhaust & get 24mpg...
I believe it was 2009 when I purchased my currant interface.
I don't know what they changed but I can assure you that mine works flawlessly.
I use stand alone data logging at the dragstrip and I have logged probably close to 100 pass's on my 2010 Camaro and it has always worked perfectly.
LOL They will be in our Photo Gallery when we get it. http://gtautopartsandservice.com/gallery2/ There are 3 LS conversion cars already in there. The Donkasaurus, a 91 k5 and a 67 Camaro. I have...
Good to know
Good deal. Conversions are allot of fun once you get a handle on them. I got a new one on a 65 GTO coming in next week.
Where did you tie all your key power wires into the factory harness?
You need to make sure they have power wile the starter is turning over.
Do Not use the factory resistor wire that powered the...
I had a 10 Camaro giving me some trouble bad flat spot and it just acted goofy at times. I found this http://thehorsepowerjunkies.com/general-automotive/weak-vs-strong-5th-gen-maf-sensor/ then...
This one was a simple fix once I started looking. The Throttle cracker enable was set at 2 mph. Raised it to 10 mph & problem solved.
Thanks Printman.
The truck was dropped off tonight so I will dig into it in the morning.
On the systems tab set security to none.
Has worked fine on every conversion I have done.
Quick question if anyone knows.
What else controls rolling idle other than the rolling idle table?
I did a 6.0 conversion from a 2002 Cady escalade (DBW) into a 91 k5 blazer.
Everything is...
I had the same 2-3 shift problem after having my 6l80 rebuilt.
After playing around with tune a bunch and getting nowhere we made a few phone calls and then went back in the trans and set all the...
Yes it is Brake torque management.
I have noticed a glitch in mine at times. Sometimes turning TC and stabiltrack off will turn off the brake torque management and allow it to rev other times it...
The best 100. you will spend on mods & tuning.
http://www.thetuningschool.com/training-courses/learn-at-home/#6speed
If you have not already you need to Contact support for Beta Software.
I believe that was it.
Thanks.
Here is the config.
I tried to upload the tune again and it will not work?
Just put on a set of Long tube headers & High flow cats on a 2010 Camaro.
Logging to see how much everything changed.
I nailed it threw first and rite after it shifted to second it cut out and...
I Got it.
I just had to pull my head out of my azz long enough to see what I was doing.
Thanks.
I guess I got to go do some more reading because I can't get it to log it
On the insert table tab MAF airflow vs Output frequency is blacked out and will not work.
Is this a problem with my computer or do I need to use another table?
I thought from your first post that you had already checked that but after re-reading it I see you just figured it was ok because it would rev clean under no load.
Glade you found it.