Search:

Type: Posts; User: Jggregory99

Page 1 of 8 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    2,062

    Nevermind... Found my answer...

    Nevermind... Found my answer...
  2. Replies
    1
    Views
    2,062

    It has been quite a while since I have tuned my...

    It has been quite a while since I have tuned my vehicles. And since then I have replaced those that were. So this will be the first time I am using 4.0... I seem to remember the tire wizard allowing...
  3. Replies
    2
    Views
    1,533

    Nevermind...

    Nevermind...
  4. Replies
    8
    Views
    5,438

    Same problem here... Didn't see a version 3.7 so...

    Same problem here... Didn't see a version 3.7 so either it is not out yet or the 7E8 ECM is not supported...
  5. Replies
    9
    Views
    4,456

    As far as I know, HP won't read a Diablo tune....

    As far as I know, HP won't read a Diablo tune. You would have to flash the ECM with a stock tune from someone with a Tech2.
  6. There is an an easier way... (New/old=Difference)...

    There is an an easier way... (New/old=Difference) x Starting tune Scalar= New Area Scalar

    So... 72/58 =1.241 x 1930.5= 2396.4
  7. Making adjustments to the VVE depends on your...

    Making adjustments to the VVE depends on your tuning strategy. Open Loop with a WB or Closed Loop with the O2 sensors via LT+ST fuel trims. Disable the MAF by setting the Maf Fail Fqz to 0, set DTC's...
  8. Well, over-fueling could very easily cause some...

    Well, over-fueling could very easily cause some serious knock and miss fire as the flame front travels further with more fuel. This could be the cause for the timing pull. Honestly, it really sounds...
  9. If it was a small change of say 58mm to 60mm I...

    If it was a small change of say 58mm to 60mm I would say yes... I could be Plug and play as there would not be that large of a difference in air... some minor tweeking could be in order, but nothing...
  10. Post tune and log.... Have you tuned the MAF and...

    Post tune and log.... Have you tuned the MAF and VE? Also, the TB area Scalar..?
  11. Replies
    22
    Views
    9,477

    Post tune and log..

    Post tune and log..
  12. Replies
    9
    Views
    3,773

    If you have a stereo to steering wheel interface...

    If you have a stereo to steering wheel interface controller installed to keep the steering wheel stereo controls, chances are.. this is your issue......Pull radio fuse and try writing in low speed......
  13. Replies
    2
    Views
    1,929

    Sounds like you bricked the PCM... Sometimes it...

    Sounds like you bricked the PCM... Sometimes it can be recovered depending on the PCM. First, put on a battery charger... remove stereo fuse... make sure you have nothing on...Lights, door chime...
  14. Replies
    51
    Views
    37,278

    The credits are not transferable or re-sellable,...

    The credits are not transferable or re-sellable, as they are locked to the MPVI through the Application Key.
  15. If you are in closed loop, you should NOT be...

    If you are in closed loop, you should NOT be using WB data AT ALL...In fact...Delete the channel for your WB in the scanner as to not get confused. You have to remember, in OL your err comes from the...
  16. Replies
    24
    Views
    8,804

    Why would you ADD timing if you are getting KR? I...

    Why would you ADD timing if you are getting KR? I mean, Correct me if I'm wrong, but, If you are adding timing and KR Max is being reached then the KR is just pulling all the additional timing out. I...
  17. Replies
    51
    Views
    37,278

    It won't ask you to license a vehicle until the...

    It won't ask you to license a vehicle until the tune can be read. If the read failed than no credits were spent. That is to say, I am assuming you are still having a locked ECM problem. It will only...
  18. Yes... I've been following your other thread Mr....

    Yes... I've been following your other thread Mr. Smith and I feel your pain.... Like I said earlier... IT'S A D**K MOVE... Hope you get it unlocked. Sadly there are some tuners out there who think...
  19. You are absolutely correct. IF they have HP and...

    You are absolutely correct. IF they have HP and use their own laptop and MPVI they could read the unlocked tune from your vehicle, but, I think you are misconstruing my point. If you are going to be...
  20. Replies
    10
    Views
    5,411

    As Schpenxel ^^^ said... Easiest method......

    As Schpenxel ^^^ said... Easiest method... However, If your particular recipient does not wish to download the VCM Scanner software... Which, as stated above, is free... You could open up the scanner...
  21. Replies
    6
    Views
    2,824

    So no chatter? I know analog can be slower than...

    So no chatter? I know analog can be slower than serial in many cases. At least it was with the WEGO IV. I had intended to wire it for serial with USB, by adding a pin to AEM #5 to a DB9, but your...
  22. True, but if you are using your laptop, How would...

    True, but if you are using your laptop, How would they get the file in the first place...?
  23. Most of the tuners here share their tunes anyway...

    Most of the tuners here share their tunes anyway if someone asks... So what would be the point.. It's not like there is huge competition in a given area that tuners are cutting each others throats...
  24. Bill, Would that be correct though.. ? You lock...

    Bill, Would that be correct though.. ? You lock it in the write screen..?
  25. I think you have to put it in the custom key...

    I think you have to put it in the custom key parameter when you are in the write window after you connect to the vehicle. Most tuners don't lock their tunes. Kind of a D**k thing to do. This is just...
Results 1 to 25 of 182
Page 1 of 8 1 2 3 4