Search:

Type: Posts; User: FieroAddiction

Search: Search took 0.00 seconds.

  1. I can now confirm it works. I have the LV7 from a...

    I can now confirm it works. I have the LV7 from a 2017 Spark, installed in a Japanese Kei truck. It was an automatic ECM, I used GM SPS with a Mongoose Pro (Ford) cable to burn a stock manual tune to...
  2. I grabbed a 2017 Spark ECM and attempted to read...

    I grabbed a 2017 Spark ECM and attempted to read it out on the bench. It won't connect with HPT or handheld scantool. The only data lines on the ECM are hi speed GMLAN CAN bus which passes through...
  3. 16-19 Chevy Spark LV7 1.4 VATS disable.

    Can someone confirm that VATS can be disabled on the 16-19 Chevy Spark with 1.4 liter LV7 engine? I'm looking at this engine for a swap into an off road buggy, but if I can't run the stock ECU there...
  4. I found it, it has been moved to a new tab,...

    I found it, it has been moved to a new tab, Engine>Exhaust. :mad:
  5. EGR master enable disappeared in new software release - P01 Gen3 V8

    Is there a reason the EGR master enable option under Engine/General has been removed? I have several vehicles running P01 PCM using the EGR position input for wideband O2. I used to be able to toggle...
  6. 2004 Explorer 4.6 manual trans swap... Problems with editor

    I've swapped a manual trans into a 2004 Explorer 4.6. I'm having some problems getting it to run properly.
    Setting the auto trans DTCs to "no error reported" prevents them from appearing, but the...
  7. I've used several different aftermarket...

    I've used several different aftermarket controllers including a Holley Commander 950 that had to be sent back twice to repair hardware failures. I'd rather stick with a cheap and reliable GM ECM if...
  8. Recommend a GM ECM/PCM for custom application.

    I need some help deciding which GM ECM to use to run a non-GM engine in a street rod. The engine is a BMW 5.0L V12 mated to a Getrag 262 6 speed manual. It has two distributors, each running one bank...
  9. Replies
    2
    Views
    2,879

    LS4 VSS out

    Is there any way to change the VSS output from serial to frequency so I can drive a speedometer directly? I've seen this option for some of the V6 cars, but I don't see anything in the LS4 editor....
Results 1 to 9 of 9