That would explain it. with the code present but not reporting will it cause any issues with inspections?
Type: Posts; User: BURNEM
That would explain it. with the code present but not reporting will it cause any issues with inspections?
That would make sense. But would the drag car with no emissions not return the same "Permanent" code? I have no rear O2's in this car and it never sends a DTC code like the SRX.
I have a Cadillac SRX with codes P0036, P0138, P0140 & P0141 set to No SES checked, and No error reported.
When the car is running there is no light on the dash, but using the scanner it pulls the...
This scan is back on the N/A tune. Ill clean the MAF and replace plugs and log another run. I have a dual stage dry then second hit wet kit.
So I took car to track and it was greatly disappointing. I made one pass with N2O and the car ran rich and sputter out shut it down swapped tunes and made N/A passes. The car didn't feel very strong...
So I guess a No Go for the Aztek? I have an 03' AWD that reads as a 04" Buick but then locks out.
I changed the gear ratio and applied it and now the car cannot shift into third at WOT until throttle is lifted. Shifts are set at 6200 and 76 mph for a 3.50 gear in second to third shift. When I...
Thanks I wasn't sure about the fueling parimeters as it is 100% stock. I will give it a try.
My wife has an 02 Trans Am A4 that I would like to use tuner to give her better MPG. I am still new to this so other than fans, and shift points I am at a loss. I have a NGK wideband ready to go. ...
Finally got it. It is a steering position sensor; C1281 Steering Sensor Uncorrelated Malfunction.
So it looks as I will have to replace rather than tune, even though my car don't need this as I...
Now it is telling me that the Door control module has lost connection. None of which is a P0 code that I can sht off. I have not touched the MAF DTC
I have a message that reads service Vehicle Soon on my drivers info screen. The owers manual reads its electrical, dealer can't seem to find it. Is there an option that I can just disable this...