Search:

Type: Posts; User: PopUpBlocker

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. I would love to see some pictures of this "98...

    I would love to see some pictures of this "98 Cavalier" instrument cluster that is supposed to have an oil pressure guage & tach which I'm pretty sure they never came with back then. It would also be...
  2. Replies
    6
    Views
    3,038

    Then yes. 2 credits would license that PCM for...

    Then yes. 2 credits would license that PCM for disabling VATS, which should allow you to start and run that engine. You also shouldn't be required to do a "Write Entire" for this PCM but if you do...
  3. Replies
    6
    Views
    3,038

    Maybe, maybe not. Nobody's going to be able to...

    Maybe, maybe not. Nobody's going to be able to tell you until you finally decide to give in to popular demand and tell us what type of vehicle and year the engine and PCM you're talking about came...
  4. Replies
    1
    Views
    3,233

    Yes. You're going to most likely hate me for...

    Yes. You're going to most likely hate me for pointing this out, but there is a huge warning that pops up before you commit credits towards license informing us that we can in fact review a tune and...
  5. Someday I'll make it! (Based in north-east U.S.)

    Someday I'll make it! (Based in north-east U.S.)
  6. Someday I'll make it! (Based in north-eastern...

    Someday I'll make it! (Based in north-eastern U.S.)
  7. Replies
    7
    Views
    4,891

    Yoy're not doing anything wrong. The newer...

    Yoy're not doing anything wrong. The newer transmissions (99 and up I believe) will always do this. They will only remain locked if under a minimum load. Go downhill or let off the gas even a little,...
  8. Replies
    3
    Views
    2,188

    While obviously paying special attention to that...

    While obviously paying special attention to that whole cigarette lighter/com port circuit for interference via shorts, bad grounds, accessories wired in, even just spotting higher than called for...
  9. Replies
    4
    Views
    2,635

    Also once you get comfortable with the basics of...

    Also once you get comfortable with the basics of this, you can learn how to log your wideband data through your EGR for temporary use of remote data recording. (just using the interface)
  10. Sorry, I kind of had the underlying feeling that...

    Sorry, I kind of had the underlying feeling that you guys knew what you were talking about and that I was a little (alot) confused here! So thanks for the clarification. Thanks X2 for the picture....
  11. Because you are new and don't know what the hell...

    Because you are new and don't know what the hell you are talking about we'll be nice for now. 'Sweep was (the first person) trying to help 68 ZO6 as well as you with some of his spare time. Not all...
  12. So, do you want to convey 3 peices of information...

    So, do you want to convey 3 peices of information using a single line in a 2D environment? No, I'm sorry I don't think thats possible.... unless you changed the color (VE) of the line (against RPM...
  13. Replies
    5
    Views
    2,778

    You are allowed to ask sales and/or tech related...

    You are allowed to ask sales and/or tech related questions here in the forum,:shrug: and should notice most inquires of this nature are resolved quite promptly when posted in the correct forum...
  14. Yep. Should've checked out the supported vehicles...

    Yep. Should've checked out the supported vehicles list or contacted support first. And even if your vehicle was covered, there's still the chance your perticular operating system may not have been...
  15. Replies
    11
    Views
    6,009

    "how do i do this" 1.) Mostly fine so far. Lower...

    "how do i do this"
    1.) Mostly fine so far. Lower PE Enable for 3000RPM and other PE table to 30% throttle position.

    2.) Leftclick hold & highlight all rows above 900RPM (above your idle) in the...
  16. Replies
    2,288
    Views
    1,644,441

    Sticky: My little bro. used to watch your show all the...

    My little bro. used to watch your show all the time! (back around '93 or '95) Don't think HPT was around yet back then though. I think they started around 2002 ish.
  17. Replies
    27
    Views
    17,805

    That's the coolest part. Took me a few seconds to...

    That's the coolest part. Took me a few seconds to figure out what that thing was. Thank god for some decent pics or else... And I agree, 10 angles definately would have been to many.:p
  18. Replies
    11
    Views
    6,009

    :secret:Add 4-7 degrees to your high octane PE...

    :secret:Add 4-7 degrees to your high octane PE table. Smooth out that table. Copy over to low octane PE table. Match those up with non-PE low and high tables.:secret:Set Base AFR vs. ECT tables to...
  19. Replies
    2
    Views
    1,828

    Well you asked.....I personally don't know.

    Well you asked.....I personally don't know.
  20. Thread: ve values

    by PopUpBlocker
    Replies
    6
    Views
    2,530

    http://www.hptuners.com/forum/showthread.php?t=557...

    http://www.hptuners.com/forum/showthread.php?t=5573

    http://www.hptuners.com/forum/showpost.php?p=61064&postcount=1
    Start here. Mainly applies to those engines. Read around the forum, ALOT. There...
  21. Actually sounds like a cool idea. Thanks for...

    Actually sounds like a cool idea. Thanks for sharing it with the community, don't know if this is a first timer for this topic or not. Only problem I see is that not every OS can set idle to the same...
  22. You forgot to mention going lefty, as well as not...

    You forgot to mention going lefty, as well as not being able to wipe!
  23. Thread: Newbe

    by PopUpBlocker
    Replies
    1
    Views
    1,777

    Although it is possible, your safest bet would be...

    Although it is possible, your safest bet would be to use your original file as your base and make changes to it as you go. Before you do or change anything: Save a copy of the original factory...
  24. Replies
    26
    Views
    12,281

    I know right!? I seem to be having a completley...

    I know right!? I seem to be having a completley unrelated but much more sarcastic problem. Whenever I go to fix my car......
    there is NO 1-800- number with Chevy that I can call to help walk me...
  25. Replies
    44
    Views
    36,174

    I believe they actually do and the process is...

    I believe they actually do and the process is most commonly refered to around here as swapping or adding a segment. Most of the time it's used in transmission related matters.
Results 1 to 25 of 48
Page 1 of 2 1 2