with fuel pressure gauge, I see 58-60 psi from idle to WOT
Type: Posts; User: rtkjadams
with fuel pressure gauge, I see 58-60 psi from idle to WOT
I have an 05 GTP that I installed 60 lb injectors... before I start tuning the maf I need help to set the injector flow rate table.
Thanks,
Ray
I figured it out.....
Ray
Im logging my AEM WB through the egr. I cant seem to figure out how to get the AFR error Histogram working.
Thanks, Ray
41957
this is the error I get
Thanks,
Ray
A little back ground 1st.........
My buddy has an 05 GTO which I did some tuning on it.
He later supercharged it and had another tuner convert it over to SD.
He is selling car now and has...
How's this? I guess we have to relog the car again... Can you look over to see if anything sticks out???
That is the tune we are running.... We orginally got a SD tune from a tuner but I wasn't able to load it to the car, so I thought I copied all the files over. I guess not...
Ray
here is the log and file
I have a GTO that Im running a SD tune. I have a hesitation right off idle on throttle tip in. What do i need to adjust to cure this?
Ray
So, can I just edit the tune I got from Whipple with HPTuners? Or do I have to start from a stock file?
Ray
Well I'm pretty impressed with my dyno results.....
602/551 on 8psi no tuning done yet.... 11.9 afr got a few blips of kr right at the top of the run (5800rpm), ran to 6300
The map would...
I installed a Whipple Blower on my 2010 Camaro SS with Manual Trans. I'm going to the dyno tomorrow, so I need a config so I can log the car while on dyno.
Thanks,
Ray
So do we have any progress on the fueling?
Ray
Well, I will answer my own question....... Yes you can, just did it today!
Ray
Can I put a 2000 GTP PCM in a 99 Regal GS and upload a Regal program to it????
Thanks,
Ray
Will HP Tuners work on a 2001 GMC Denali??
Ray
No codes..... what kind of info do you need?
Ray
I set the "Boost Test Enable RPM" to 7000 rpm for both 60 & 100. Then turned the MBC til we got to 24psi and when I went to do a 4th gear pull on the highway, but after a few secs ALL Boost was...
So, the stock boost gauge only will read up to 22.5psi???
Ray
I started with 1 deg at a time and it is getting better!!!!! Is thing RIPS!!!
Ray
what kind of changes in the tune can I make to help spool upgraded turbo sooner???? Will increasing timing help?
Ray
Im having trouble getting the scanner to log AFR's....... Can someone share with me there Scan Config so I can log AFR's...
Ray
Cool thanks.... Gonna go start increasing some timing.
Ray
I want to start increasing the timing alittle at a time, which of the timing tables do I start increasing? So If I want to increase timing by 1*, do I change it in all four tables and in the same...