Search:

Type: Posts; User: Luweegy

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. edcmat-l1 Is this something you could retune for...

    edcmat-l1 Is this something you could retune for me? I realize this isn't a GMPP tune.Should I move this post some where else?
  2. Surge @ 2000 rpms,Idle goes up after I stop

    DSTECK,
    This is my tune.I've got a surge @ 2k rpm's and after i come to a stop the idle will creep up to 1400 rpm's? NW 102 TB,Lsxr 102 intake.Cam Specs are,SDPC Super stick 4,248/262,113 lobe...
  3. I get this symbol when I try and open my history change log.

    I have to click on it 6 times to get to my change log. it Get Constant
    ID:4001
    ...
  4. Installed a Nick Williams TB.What do I have to Change in my tune?

    I installed a NW 102 TB on my 06 Z06.What do I have to change in my tune?
  5. I thought I would post a update on this...

    I thought I would post a update on this problem.Turns out it had a 3:90 rear gear.I set it for that used autoscale and all is good.Thanx for the help Guys!!!
  6. I Ck'd the trans oil level and fluid condition.It...

    I Ck'd the trans oil level and fluid condition.It was down a pint.Smelled fine.Russ, I just called Dynotech with the rear end serial # it has a 3.90 gear.26" tall drag radials.I got this car not...
  7. I tried your tune edcmat, still doing it.1-2,2-3...

    I tried your tune edcmat, still doing it.1-2,2-3 hits the rev limeter.Should I raise the fuel cut off to 6700 RPM's?
  8. I see it now.I didn't know you reworked my tune....

    I see it now.I didn't know you reworked my tune. I will put that in tomorrow and let you know.Thank You.Update, I tried your tune.Same problem.Another thing I will add is it shifts at 2k RPM even...
  9. Thank you, I will adjust that and see what...

    Thank you, I will adjust that and see what happens.Should I drop my shift points 5mph?
  10. I will try that

    I will try that
  11. Yes it is.What is wrong with the speedo?I'll go...

    Yes it is.What is wrong with the speedo?I'll go look at it now.
  12. 2002 P1sc C5 Vette won't shift out of 1st gear before hiting Rev limiter

    I've tried to figure this out,Newbe to trans tuning.I had someone look and adjust for me.But the same result.3:42 gears,2600 stall,3.75 pulley.It hits the rev limiter in 1st gear before shifting,...
  13. Replies
    2
    Views
    1,754

    Can't read a LS3 Gmpp crate motor?

    I have the Beta Version and have read and tuned a 2010 Camaro LS3 with a Novi super charger. Can't access the crate motor ?
  14. Replies
    10
    Views
    7,040

    I understand opening the 2 files Do I rt click to...

    I understand opening the 2 files Do I rt click to copy everything over?Thanx for the help. I have such a mental block when it comes to understanding these tuning programes for some reasonI just can't...
  15. Replies
    10
    Views
    7,040

    I've got a tune I bought credits for,06Vette LS2...

    I've got a tune I bought credits for,06Vette LS2 tune with cam,headers, and a K&N ais. I want to put this same tune in another 06 LS2 Vette I've done the same mods to.I know I have to use 2 credits...
  16. Replies
    10
    Views
    5,111

    Got anothe ? What color wire am I looking for off...

    Got anothe ? What color wire am I looking for off the TPS on a 01 Vette?And what wire color and posisiton on the PCM is the tach signal.I'm all wired except for this and don't have a C% GM manual...
  17. Replies
    6
    Views
    3,113

    Pinched wire from bell housing removal? I had...

    Pinched wire from bell housing removal? I had that happen once and it ran like it was on 4 cylinders.
  18. Replies
    10
    Views
    5,111

    I'm gona use TR-6's to start with. Thanx for the...

    I'm gona use TR-6's to start with. Thanx for the help so far.
  19. Replies
    10
    Views
    5,111

    [QUOTE=madvette08;221223]Start with 12 degrees of...

    [QUOTE=madvette08;221223]Start with 12 degrees of timing from 0.60 cylinder airmass and higher and 2800 rpm and up.

    Add 10% fuel from 2800 and up in the Power Enrichment EQ Ratio vs. RPM table....
  20. Replies
    10
    Views
    5,111

    Need help with a NOS tune

    I've got a tuned LS6 24018 Can someone help with a wet plate 100-150 shot tune?
  21. Replies
    43
    Views
    84,413

    What is the setup if I'm using a AEM wideband?

    What is the setup if I'm using a AEM wideband?
  22. The code it had said no comunication.So Another...

    The code it had said no comunication.So Another predator burns a PCM.4rth differant car this summer.06 vert,03 Terminator,03 Saleen Terminator and now this one.WTF good thing I'm in Colorado and...
  23. Need help,Preator aborted tune,car won't start

    I've got a 04 C5 that had a predator tuner in it.I was changing fan temps and reloading the changes.The tune aborted,set a code,that said no comunicatio to the TB.The car won't start.I was gonna tune...
  24. Thread: Code po 621

    by Luweegy
    Replies
    1
    Views
    2,833

    Code po 621

    I've tried to turn of this code.it is F terminal on alternator.I'm getting ck charging system on the DIC in my 06 Z06 everytime the rpm's are low or coming down to idle.I've turned off other codes.Am...
  25. Bill, has anything been done to get the fan to...

    Bill, has anything been done to get the fan to come on before 192 degrees in the Z06 LS 7 tune yet? Thanx
Results 1 to 25 of 41
Page 1 of 2 1 2