sweet thanks
Type: Posts; User: Turb0Z28
sweet thanks
After you enable the sensor will hpt able to read it?
I am happy I found this thread! I have a 16 non flex fuel. I am going to order some an fittings and flex fuel sensor. Cut the stock lines and flare the line and flex fuel sensor.
I know its not a v8 but the v6 section is dead. i know the v6 and v8 are the same - the bolt pattern.
I am putting a L67 from a 98 Regal GS. Into my Merkur XR4Ti. Can found a good deal on a 4L60e...
I am putting a L67 from a 98 Regal GS. Into my Merkur XR4Ti. Can found a good deal on a 4L60e out of a v6 2000 Camaro. They will bolt up.
1 will the wires connect together?
2 if not can i just cut...
I am doing an engine swap from a 98 regal gs. I have all ready have hp tuners and unlocked the car. I am pulling the motor to do a swap in a Merkur XR4Ti. I will take the motor wire harness and ECU....
also the SD chart is blank i cant see it
I have a 2000 turbo Camaro. I switched my tune to a 3 bar SD and the car will not start. I put the stock tune on when the 3 bar gets vacc the car dies.
My buddy has an 06 f-150 what had its cat's removed and duels pipes added.
he says it runs like shit. The exhaust work was done before he got the truck.
could I just delete the rear o2s will that...
pm sent to ya bill
i want to tune using the new interface. is it posable to have 2 interfaces shair i laptop? how do i regaster the new one?
o its a OI
i got it. now is it ok to plug it in to my lap top?
will it use my pro credits?
how does it work the inter fave i scan the new cars with will be the licenes i use?
how do i create a custom pid?
i have HPT pro. i found a guy on a local forum selling his hpt.
he said it is licensed for 2000,2001,2002 fbodys and for 2004 GTO.
1. How can i tell if thats right?
2. He also said it 2 years...
???? what does that mean?
i think my settings are wrong i just changed it to psi and the car at idle is showing 4.5 psi and at WOT it reads 23 psi on a stock car.
this is all a old scan i am looking at
so in kpa what is boost and waht is vac? i just look at the scan and it hit 158.0 kpa how do i get it to say psi? i tryed once and it still reads the same #s as kpa
o what map shoud i get for a 00 ls1?
How do i set up the map to read boost and vac? in the scan of my ex's gtp it it would not read boost.
cool it works thanks!
just like this? but use the 2.2.0 right.
http://www.thetuningdoctor.com/HPTuners/FlashDemos/installer.swf
i did
down loaded it. but when i open hpt it still says 2.1.18 on in. did i do it wrong?
i have a 96 cavi. i want to put in a 97 or 98 ECU so i can tune it with hp tuners. i know that the engine is prity much the same just the intake and crank sensor are diffrent. what all do i need to...