Search:

what's your email and I'll see if I can send you my old tune.

http://i247.photobucket.com/albums/gg131/keith42_01/DSCF0366_zps5282c410.jpg

When I click on the Beta warning, the wideband doesn't show up. If I go back and look at my old stand alone logs it...

http://i247.photobucket.com/albums/gg131/keith42_01/DSCF0365_zpscb71ba5a.jpg

You can see that the wideband is on the screen.

Is there a place I can load the default config from? I've been having problems with it freezing as it says it's loading a firmware update.

Really? It's what It says across the top of the datalog.

OK, I think this is it. Thank you for the help.

vcmscanner.cfg?

I attached 2 logs in post 5, one is stand alone the other is with laptop.

Doesn't even show the fields being empty. Just doesn't show the fields period.

Well I went out again and did it EXACTLY like the help page again and it doesn't show any of the inputs or outputs on the data log, this is only for the stand alone logging. I've been datalogging...

Ok I do a datalog, I go under scan, click mvpi pro, I click read selected, it makes me save to my computer, I find it in my computer and click on it and it brings up the log.

What is not correct?

I think I'm doing everything correct, follow step by step. In the datalog it isn't even showing the E/O inputs being blank it doesn't show those fields at all.

4353443535

The transbrake log is attached to the laptop, the testlog is stand alone.

I'm not exactly sure what that means, my datalog config that I use connected to the computer has wideband reading, I tried rewriting the stand alone config and it still doesn't show any E/O inputs or...

how do I do that? Thanks for the help.

when data logging with the computer my wideband shows up in one of the E/O inputs but when I data log without the computer it doesn't show up. Can someone tell me what I'm doing wrong?

details
390/ etp 245 head
Gt4788 turbo
E85, bosch 127lb injectors

I just switched the car over to E85, the car has a little bit of idle surge in neutral but when I put the car in gear it is...

thanks

I've heard this and I've seen many people who subscribe to this in their tuning. Also is there calculations and tables that aren't visible in hptuners that affect timing? I have seen timing pulled...

I think I found the wiring issue on my Firehawk, this morning I was doing some inspecting of wires and I noticed a very small spark. gauge 4 starter wire, visually it looked fine. But with the...

OK thanks, I'll try that, I did replace the stock alternator with a larger truck alternator when this started happening. I thought the stock alternator seemed marginal.

what is unplugging the alternator going to prove or disprove? I didn't do a pull but disconnecting the alternator dropped the voltage to 12.0-12.2.

Tried that, no difference.

Is there a common ground that would cause it?

Does anyone have a schematic for the power wires from the engine bay thru the ignition switch?

getting really bummed out that I can't get this figured out.