FIXED.
I was in the process of checking the TPS voltages, and noticed that with the engine not running the throttle would work perfect. Knowing this, it couldn't be a hardware fault. So I began,...
Type: Posts; User: 00 Z
FIXED.
I was in the process of checking the TPS voltages, and noticed that with the engine not running the throttle would work perfect. Knowing this, it couldn't be a hardware fault. So I began,...
it's worth a try, i'll get the old volt meter out and backprobe it this weekend.
I might take a look at that, but all the factory ECU wiring is O.E., we had to splice nothing into the main PCM harness. The pedal had all the wiring to the box underhood and then to the PCM. We were...
:doh: I bet that's what happended.
lol, it's got me totally confused. It has to be because it's not seeing something, an input or something it needs.
i'll just keep on truckin, if ya got any...
Gave her a try, but didn't seem to help any. Also, i noticed that if it idles long enough, it dips really bad, the throttle position drops to 0%, then back to 4 and it idles normally.
weird.
...
No, a CASE learn was never performed. Although this PCM/engine combo was all from the same parted out truck. It apparrently fell off the transport truck when new, the motor had only 5 miles on it.
...
Ok, got the table changed, although the problem still persists. Here's a vid of what it's doing and the current tune.
Vid: http://www.youtube.com/watch?v=cPKaCTgOtuI
The rev limiter is at 6400,...
Thanks 12sec. I'll get the table checked hopefully tonight for ya. As for the VSS, it was in the works soon as it does cause some idle concerns, mainly when decelerating as it drops to idle when you...
looking at my 1st post, i also forgot to mention that this truck has no VSS input. Also, it has no range selector input, it appears to be disabled in the tune, as the PRNDL is set to none. All the...
Thanks 12 sec, i'll get out to the shop and give that a try tomorrow or so. i'll post back the findings, again, thank you!
Well, nobody has ANY idea, not even the original programmers. This is a real problem, when launching on slicks it bogs bad at 3K, then picks right back up and goes to redline. It's only on a hard...
I've fiddled without about every table as far as torque management goes, as well as done a search here. Maybe this is a problem that nobody has ran into? I'm planning on calling the people who did...
bump
Almost forgot, here's the current config file.
Ok, here's the log. It didn't capture the throttle hiccup on the long 0 to 70 run, but at the end of the log, I blipped the throttle 3 or so times, on the 1st try you can see the Pedal Position is at...
10-4, i'll get a log file posted in the next few days. I would assume Pedal Position, Throttle Position, Desired Torque, and RPM would be the ones needed?
bump
Working on an '03 5.3 conversion into an '86 GMC, 3500 Stall, TH 350 Trans, stock 5.3.
Truck runs and drives great, the computer was tuned by Texas Speed before we got the HP tuners software and...