Having a hard time building low end power on our ls gen 3 and 4 programming. All of our torque management stuff is turned off (to the best of my knowledge anyways) . Fuel trims look good, especially...
Type: Posts; User: mcarmack
Having a hard time building low end power on our ls gen 3 and 4 programming. All of our torque management stuff is turned off (to the best of my knowledge anyways) . Fuel trims look good, especially...
6642066420
I am certainly not an expert at hp but have done several tunes. On these trucks, I normally go into the power enrichment table and lean it out a little bit and it helps a lot. doesn't...
I just completed a performance tune for a customer with a 2006 ford mustang with v8.
he also ask for it to shift harder. Im assuming I can just increase the line pressure for more firm shift but...
I have a customer with a 2006 ford mustang GT . They are requesting that I tune it for performance, and they also have a complaint of it "bogging down" momentarily when it upshifts to the next gear....
I have found that I cannot tune PCM's on 1996-97 PCM's because there are internal differences between them and a 1998. So I have changed 1997 trucks to a 1998 PCM before so that I can tune them....
motor was rebuilt, its very fresh. only bolt ons are headers and cold air. everything else factory, stock cam .
56903
I put a 5.3L in a 1984 k20 truck. came out of a 99 or 2000 truck. I have performed a basic tune on it, turned off all EVAP, EGR, Sensor 2's, speed limiters, COT, theft deterrent, and leaned...
Also yes the file I attached is from before I edited anything
The vehicle runs right now , it just doesn't idle well . Seems to clear up with giving it throttle , but will die after it comes back down from WOT. I don't think this can is a whole lot bigger than...
replaced a 5.3L with a performance 6.0L (ordered through oreillys) (specs for engine are listed below) . using same injectors. I already changed the tune on it, but all I done was change cylinder...
no other engine modifications that I know of. it is a work truck 6.o liter with cast iron block
48544
Im still new to hp tuners and figuring a lot of stuff out still. I recently had someone bring me a 5.3L truck that they put a 6.0L in it. The truck will barely run, doesn't run well at all. What do...
thank everyone for there help. that helped a lot. I changed eq ratio map in PE. what would be the best thing to change at cruising speeds for added fuel economy?
thank you... exactly how do I lean it out though? I don't see a map in PE to adjust AFR
im tuning a 1999 Silverado with 4.8 or 5.3.. still fairly new to hp tuners. Im turning off the theft deterent on it , but he also wants a tune in it for added performance but nothing too radical....
I have tried that already . Every other tab pops up after I click on it except for this one , I can see the tab , and I can click on it . It's like my vcm editor software is bad ??
I have tuned 2 different vehicles and everything works fine other than attempting to access the speed limiter tab. when I click the "speedo" tab at the far right I get a hour glass for just a second...