ive done a complete rewrite of the operating system as well.
Type: Posts; User: wildside
ive done a complete rewrite of the operating system as well.
4.941 volts
my 04 gto is setup to run 3 bar map sensor with my plx wide band
im trying to tune a stock, cam , cai 04 gto, the problem is its still seeing my car, i've reset the last vehicle and rebuilt the...
I was haveing the same problem, I turned off my short term fuel trims along with the long term fuel trims and no more rich start up.
Ok figured it out, my scanner was setup on a 2 bar, this car is NA so needed to build one from scratch. Just info for anyone else.
I have been using a PLX wide band setup for over 6 years now and done a lot of tuning on different cars but by know means an I an expert, so a guy has his car tuned by a shop and it was throwing...
bought the truck used and this is the tune thats in it, safe or bogus tune?
ten four, thanks.
just started with the new beta, thanks.
04 gto, as soon as I start to log I get service guages and my fuel guage goes to Empty? Just down loaded the new beta 2.23 and useing windows7 as of friday 9-16-2011
my old computor crashed lol
thanks bill.
sorry a few things about the car, its 3 bar SD tuned, procharged,cam, etc.
when I setup to log his car the ve ltft,ve stft, ve wideband, ve afr error, I get this
If this Histogram references Tables, it is possible that the vehicle
you are connected to does not...
thank you sir.
yes this is an ls1 pcm, and that suxs lol
well if its maxing out then does it continue to follow the last line to infinity or it just reads what the last line is??
thanks for the help.
I'm running a 2 bar speed density C/O system I see around 180/190 on VE KPA table
Is there a way to raise this table to read higher then 120 G/CYL?
...
I guess it ok to have both lol
i'm running a 2 bar speed density tune, i've taken the maf completely out of the car, i'm getting two codes p0102 and p0103, I know I need one of the codes to go SD, but if i'm getting both will the...
try this
no the ls2 is totally different.
post tune and log, only way to see or help you.
well for one its a pain in the arse to get to it with the s/c lol, I knew I would go that route after getting the 5-6 psi tune Maf down, then upping it to 10psi and going speed density.
I put a tvs2300 on my car and installed a 2 bar map sensor, can I still tune the car like it has a factory map sensor or do I have to go 2 bar speed density?
yes the lower the number the quicker the shifts, yours looks fine.
http://www.alcohol-injection.com/3-bar-map-sensor-21.html
maybe this site will help not sure