Search:

Update: ripped my intake off and installed my original cam sensor. I then checked the electrical circuit between my sensor and pcm, which was ok. Put it all together, reset codes, and it started...

Need to do some work. Unplugged the battery for an hour, plugged back in, fired right up. Dont know why but it decided to throw codes. P0342, P0343, and and a mass air flow (this was one is...

tana99ss started to help me out yesterday looking at my tune as well. I did load your tune up and definitely was responsive on that tune but smelled super rich and never fired up. I think I have an...

Ok, so I got the engine running again and noticed I have some DTC that I need to look at. Not setting of check engine light but could be yet another issue to my hard start. P0342 for my cam sensor...

I went ahead and adjusted my VE based on the feedback on the post you share. I backed off the VE table since my cam is not that big. I went ahead and multiplied 0.9 across the 400rpm, 0.95 across...

The thread you shared in your first post is super helpful. I never even touched my VE or MAF during my initial flash. This is most likely my culprit to idle issues and not holding the idle/not...

Also, please do share your tune file. Comparing what you have would help get me in the right direction.

Man, I appreciate you helping out! I attached my cam card below, came through weird. Will wait to see what it looks like after I hit reply to Thread. I honestly said that wrong about the STIT and...

Looking for advice and assistance getting my Gen 3 5.3L idling. Everything on the girl was left stock except upgrading the rockers, valve springs, and cam shaft.

Cam Shaft - BTR Stage 2 Truck...