Search:

Type: Posts; User: danieloneil01

Page 1 of 5 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    5,225

    Just don't do this during the heat of the day. ...

    Just don't do this during the heat of the day. Tuning OLSD is chasing your tail if you get heatsoaked. It's not as simple as taking all the numbers in the VE-AFR% and pasting the difference in the...
  2. Replies
    11
    Views
    4,207

    Are you logging both injector pulse width banks...

    Are you logging both injector pulse width banks and flow rate?
  3. DFCO is set at 285* for all of it. I'll just...

    DFCO is set at 285* for all of it. I'll just live with the swings I guess. If I lift the pedal and just coast to a stop the AFR will stop swinging around 10mph or so if I remember correctly.
    ...
  4. Well I've went back to injector data that a tuner...

    Well I've went back to injector data that a tuner gave me for my motron 60# injectors. I've lowered the TPS enable to 20% and MAP enable to 75kpa and the Rate to 2.0. It always gets the lean spike...
  5. Lean spike going from part throttle to WOT

    I have it in OLSD because I'm getting annoyed at the AFR and RPM swings coasting either in gear or not in gear.

    I've tried using the BE table and letting the car be leaner in the PE table but for...
  6. Replies
    5
    Views
    4,131

    Good luck on getting injector data if it's not on...

    Good luck on getting injector data if it's not on the net somewhere. People are secretive.
  7. Replies
    6
    Views
    3,738

    That is a lot of stuff you're logging that...

    That is a lot of stuff you're logging that doesn't need to be.
  8. Replies
    2
    Views
    1,843

    So I need to buy a MAF and use it for the...

    So I need to buy a MAF and use it for the inspection? I remember BB telling me just to tune out the rear O2s but I'm assuming the ones that say incomplete in the scanner are the rears. Aren't they...
  9. Replies
    2
    Views
    1,843

    DTC codes

    I put the reverse to 3 just now and haven't loaded to the car yet. But I don't have the rear O2s hooked up but have them tuned out. I also thought I had everything right for the MAF to not show up...
  10. Replies
    5
    Views
    2,582

    22* of timing??????? I would start at 12 and...

    22* of timing??????? I would start at 12 and work you're way up SLOWLY. Do you use meth or water injection?
  11. I've read that it means the injector data is...

    I've read that it means the injector data is wrong.
  12. Replies
    12
    Views
    3,813

    Then start at 20 and keep making passes while...

    Then start at 20 and keep making passes while increasing the timing each time in small increments. Back off the timing if it doesn't go faster or you get knock.
  13. Replies
    7
    Views
    2,768

    Why so much timing?

    Why so much timing?
  14. Replies
    4
    Views
    3,243

    http://www.hptuners.com/forum/showthread.php?38303...

    http://www.hptuners.com/forum/showthread.php?38303-Need-a-little-help-with-SD-tune-hard-start-after-reflash&p=347378&viewfull=1#post347378
  15. I just did this after loading a new tune and the...

    I just did this after loading a new tune and the car started without having to touch the gas pedal. Thank you.
  16. Replies
    14
    Views
    5,260

    Why does it idle so low?

    Why does it idle so low?
  17. Check in box :)

    Check in box :)
  18. When I load a tune and start the car right after....

    When I load a tune and start the car right after. As for trying to get it to fail, mine has always done it. I set the 3 DTCs to option 2 as option 3 prevents my car from running and I have the...
  19. Mine does this to after loading a tune but not...

    Mine does this to after loading a tune but not nearly as bad as the one in the video. I can keep it running on the first start but it's a bit tricky. Then after a few seconds it acts like it wakes...
  20. Replies
    27
    Views
    39,368

    Final tune and I will say I have lowered the...

    Final tune and I will say I have lowered the timing across the board due to KR (could be to rich during part throttle but I'm no expert) and also turned on STFTs due to heat soak in the summer which...
  21. Replies
    27
    Views
    39,368

    My car was tuned by someone else and the TPS % is...

    My car was tuned by someone else and the TPS % is pretty low, see below.

    Labels 0 400 800 1,200 1,600 2,000 2,400 2,800 3,200 3,600 4,000 4,400 4,800 5,200 5,600 6,000 6,400 6,800 7,200...
  22. Replies
    8
    Views
    6,581

    Click the link and a PDF will pop up taking you...

    Click the link and a PDF will pop up taking you step by step. MAF tuning starts at page 13. If you're trying to recalibrate the MAF then it needs to be plugged in.
  23. Replies
    27
    Views
    39,368

    Very good write up.

    Very good write up.
  24. Replies
    8
    Views
    6,581

    I'm no expert but why would you have any fuel...

    I'm no expert but why would you have any fuel trims on? It's going to always try to add or subtract fuel to go back to stoich.

    Click this link and go to page 13 ...
  25. Replies
    8
    Views
    4,193

    Mine always wants to die after loading a new...

    Mine always wants to die after loading a new tune. I was under the impression that's normal. Always starts up the 2nd time just fine. Most of the time I can feather the gas on the first startup to...
Results 1 to 25 of 107
Page 1 of 5 1 2 3 4