Search:

Type: Posts; User: BlurrSpeed

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Version 3.6 autosaves the logs when you stop...

    Version 3.6 autosaves the logs when you stop scanning. They are in the "%USERPROFILE%\Documents\HP Tuners\Logs" folder. It may be available before this version.
  2. Replies
    7
    Views
    3,920

    I have not messed with the VCM scanner in some...

    I have not messed with the VCM scanner in some years. No car to play with. We recently bought my daughter a 2002 Cavalier with an EcoTec. She is only 12 so I have to drive it for her. :cool: I...
  3. Replies
    2
    Views
    2,066

    Is the GM 2.2L OHV supported.

    I have a 1999 Pontiac Sunfire with a 2.2L OHV (pushrod) engine. The VCM 3.0 Supported Vehicles says 1997+ Sunfire/Cavalier 2.2/2.4. Now the Ecotec did not come out until 2002 in the j-bodies & the...
  4. Enhancement Request: Support for Saturn 1.9 L SOHC/DOHC.

    This is probably a futile request but I just picked up a 1997 Saturn SC1 . I have always liked that generation but never really looked into buying one. A few months ago I had the opportunity to get...
  5. Replies
    0
    Views
    1,523

    Amp draw to the EIO pins.

    I want to log braking so I am helping my son build a step down voltage regulator to bring the 12V (9-14.5V) from the brake light switch down to the 5V needed for the MPVI Enhanced IO pin. I would...
  6. Replies
    7
    Views
    3,920

    I would like an auto save for 2 reasons. One is...

    I would like an auto save for 2 reasons. One is may laptop battery does not hold a charge for long and if I hit the cigarette liter plug and dont notice its unplugged the laptop dies. I know sleep or...
  7. Replies
    29
    Views
    17,912

    2005 Cavalier 2.2 Ecotec. Added a wideband O2...

    2005 Cavalier 2.2 Ecotec. Added a wideband O2 that bypassed the ECM O2 heater, P0135 DTC. I disabled the by unchecking the SES Enable. Readyness was not check for this on the emission test. I also...
  8. Replies
    2
    Views
    2,345

    My biggest hurdle was learning to work and read...

    My biggest hurdle was learning to work and read the histograms.

    I have an L61 running Alph-N so I dont know much about MAF tuning. After driving and changing things to see what feels best, has...
  9. Replies
    1
    Views
    1,277

    VCM Editor fuel charts unreadable

    I've about got my fuel tables worked out & now I need to smooth out the cells. I would like to do it by using the chart but the way the chart is setup the high load/high throttle position area hides...
  10. Replies
    24
    Views
    10,877

    This is based on my limited experience with my...

    This is based on my limited experience with my 2005 NA 2.2 Cavalier.

    I ran your log through my gauges and I think the P0171 code may be caused by maxing out your fuel trims. STFT adds almost 40 &...
  11. Replies
    4
    Views
    2,857

    Did you re-calibrate the wideband for E85?

    Did you re-calibrate the wideband for E85?
  12. Replies
    5
    Views
    3,299

    Tuning flex fuel vehicles

    OK Payne4life I found something for ya. I searched the tune repository & found an S10 2.2L auto that looks exactly like my 2005 Cavalier except there are some spark tables marked "(Alcohol)". I have...
  13. Replies
    5
    Views
    3,299

    If you can find someone in your area that has an...

    If you can find someone in your area that has an HPTuner it does not cost anything for them to read your ECM. Then you can post it.

    I am guessing, having never looked at the flex fuel tables, that...
  14. Replies
    5
    Views
    3,356

    I dont know much about the electronics involved...

    I dont know much about the electronics involved so Id go with Leafy's latter suggestion of setting both enable & disable VSS to 0 MPH. This may not work due to the "Enable VSS". Then you could play...
  15. Replies
    3
    Views
    2,694

    Intake Air Temperature (IAT) vs VE compensation...

    Intake Air Temperature (IAT) vs VE compensation table.

    Another thing I noticed is while driving around in open loop with an IAT in the 75-90 range the AFR from my LC-1 wideband is in the range of...
  16. Replies
    2
    Views
    2,966

    Error: "The interface was not found."

    When the VCM Scanner is connected the VCM Editor gives an "The interface was not found." error. To remedy this you need to go back into the VM Scanner and disconnect the interface, unplug/re-plug in...
  17. Replies
    3
    Views
    2,694

    More L61 Ecotec tables.

    I have spent the last week tuning the VE Low RPM tables to get a lean cruse of 15.4. I noticed looking at other tune files that there are Stoich AFR tables that could have made this work a lot...
  18. Thread: Android

    by BlurrSpeed
    Replies
    7
    Views
    5,786

    Yes. If for nothing but gauges and viewing logs....

    Yes. If for nothing but gauges and viewing logs.

    Acer Iconia A500
  19. Replies
    4
    Views
    4,169

    I am going to through this out there & I could...

    I am going to through this out there & I could out of my head.

    I seem to recall reading or seeing a video of injectors firing twice per ignition. It fired once in normal position at or just before...
  20. Replies
    0
    Views
    1,420

    Not able to create histograms

    I am having trouble creating histograms. If there is a post on this that I did not find please point me in that direction.

    I create logs logging about everything I can. When I go to setup a...
  21. Replies
    5
    Views
    3,625

    A little more info. I have a 2005 Chevy...

    A little more info.
    I have a 2005 Chevy Cavalier and installed an Innovate LC-1 wideband controller. In the default configuration it has one output for the gauge and the other is configured for...
  22. Replies
    1
    Views
    2,427

    Standalone Gauge panel.

    The gauges one can setup on the computer while scanning and playback are great. It would be nice to have a 4X8 inch or so panel that we can configure several gauges to add to or replace the stock...
  23. Replies
    8
    Views
    4,773

    On the 2003-2005 Cavalier the DRLs are probably...

    On the 2003-2005 Cavalier the DRLs are probably not controlled by the ECU. On My base model there is not much that is other than the engine so controled by the ECU is not an option.

    As mentioned...
  24. Replies
    1
    Views
    1,874

    Yes. We need more stuff for the L61.

    Yes. We need more stuff for the L61.
  25. Replies
    7
    Views
    5,919

    1st thanks for the real info and not a bunch of...

    1st thanks for the real info and not a bunch of guesswork. It would be nice to get the logs so we could look them over in real-time.

    Maybe I missed something in the thread but is there a time...
Results 1 to 25 of 29
Page 1 of 2 1 2