Search:

Type: Posts; User: ivmotorsports

Page 1 of 2 1 2

Search: Search took 0.00 seconds; generated 11 minute(s) ago.

  1. Replies
    6
    Views
    2,631

    Make sure you "write complete" rather than just...

    Make sure you "write complete" rather than just calibration
  2. Replies
    0
    Views
    775

    2011 4.3 swap MCP fault

    I'm looking for ideas on fixing intermittent dead throttle on a 4.3 swapped rover. It does set a generic MCP fault but won't tell me why. Anybody else run into this? The engine is stock.
  3. Replies
    2
    Views
    2,209

    It has been three days of trying different...

    It has been three days of trying different approaches. The things I've done so far:
    Part throttle shift tables have been moved 20 mph earlier.
    TCC disabled for shift
    TCC disabled completely...
  4. Replies
    2
    Views
    2,209

    4L80 won't downshift at highway speeds

    There has to be something I'm missing. Once it hits 50mph it won't downshift.

    It is a swap into a 72 k15.

    ON the log from 1409 to 1411 I cycle the throttle to wot and it stays in 4th. If I...
  5. Replies
    3
    Views
    1,716

    I would tend to agree, but it runs when I...

    I would tend to agree, but it runs when I reinstall the original tune. The only changes I made was enabling codes for vent and FTP. I emailed tech support and am waiting for their guidance. I know...
  6. Replies
    3
    Views
    1,716

    Anybody know where the VATS tab is in the new...

    Anybody know where the VATS tab is in the new revision? That has to be the problem, crank and cam patterns look great, data shows good cranking RPM, but no injector pulse and no spark.
  7. Replies
    3
    Views
    1,716

    ls3 crate p0512 code starts and dies

    It has been running for a couple weeks. I added a vent valve and FTP sensor so evap monitor will be enabled, now it won't run. I can't find the antitheft in the new revision, maybe that's it. ...
  8. can't get oxy sensor monitor to set...stock tune

    Maybe I'm missing something. I've put 2100 miles on it going through the correct drive cycles and can't get oxy sensor monitor to drop in. Its an 07 srt8 cherokee with a cold air kit and a cat...
  9. Replies
    1
    Views
    1,490

    Freaky cruise control gremlin

    I need to post this up before all my hair is gone. 08 gt500, forged, ported, cams, kenne bell, 4r70w with manual valve body. The cruise doesn't work. Now here's where it gets tricky. The light...
  10. Replies
    333
    Views
    265,741

    I've got a blown 2010 camaro that im trying to...

    I've got a blown 2010 camaro that im trying to tune the vve on and I can't find a way to turn off the stft. no matter what I try it still does what it wants, does anybody have a way of turning them...
  11. Replies
    6
    Views
    2,988

    It is a transplant. I was hoping for a "key-in"...

    It is a transplant. I was hoping for a "key-in" fix rather than a "reflash, relicense, reload all tables fix." I remember having a problem with antitheft on one of these before, but I thought I had...
  12. Replies
    6
    Views
    2,988

    lookie

    lookie
  13. Replies
    6
    Views
    2,988

    disabling anthitheft

    I'm used to seeing pwm/serial/none under the security tab. For some reason I don't have a "none" option. The ecm is 97 buick park ave ultra, 3800sc in a fiero. Do I need to look somewhere else to...
  14. Replies
    8
    Views
    4,159

    I have the same issue. No current gear pid. Is...

    I have the same issue. No current gear pid. Is there anything new on this. Vehicle is avalanche 2500 with 8.1 and 4l80e.
  15. Replies
    2
    Views
    2,191

    Mark this under FYI. I went to the trans shop...

    Mark this under FYI.

    I went to the trans shop to pick up the car. He pulled a converter clutch off the bench and handed it to me. Its dinky. I had no idea they were so small.

    So here's the...
  16. Replies
    19
    Views
    10,556

    Your release tables are higher than your lock...

    Your release tables are higher than your lock tables. I think they would make more sense if they were lower than lock.
  17. Replies
    2
    Views
    2,191

    And another opinion, but I don't know if this...

    And another opinion, but I don't know if this will cause the slip and heat.

    # It's set to lockup in 3rd gear as early as 50MPH under light throttle (25% TPS)
    # It looks like they tried to have it...
  18. Replies
    2
    Views
    2,191

    05 corvette input/output speed problem

    The car is an 05 corvette ls2, 4l65e, procharged, built trans, converter and 4.10's.

    The tune is canned from procharger with the exception of shift speeds and "t err" to 4.10. Speedo is correct...
  19. Replies
    9
    Views
    4,202

    I wasn't aware the 99 and the 02 were a different...

    I wasn't aware the 99 and the 02 were a different OS. I had the ecm reflashed with the 99 os and will have the tuning transfered shortly. Again thank you for the explanation.
  20. Replies
    9
    Views
    4,202

    I was trying to avoid licensing the car again. ...

    I was trying to avoid licensing the car again.

    Thanks for your time.
  21. Replies
    9
    Views
    4,202

    I read and reread this explanation. The vehicle...

    I read and reread this explanation. The vehicle is licensed, I have been working on the tune. When I click on the change tune option the error screen comes up before the new vin entry screen. I...
  22. Replies
    9
    Views
    4,202

    :drivin: I reread a bunch of the posts under...

    :drivin:

    I reread a bunch of the posts under the "search" function. I think I might be misunderstanding what "change Vin" is for although it looks self explanatory...

    Can HPT change VIN's?
  23. Replies
    9
    Views
    4,202

    changing VIN not working

    I have a client with an 02 ls1 in a 99 z28. I have already been working on the tuning, but now I need to change the VIN for smog. When I open the change VIN tab it gives me a "not licensed" error...
  24. Does this fully disable the VATS or just the...

    Does this fully disable the VATS or just the error reporting for the check engine light?
  25. Replies
    1
    Views
    1,957

    replacement disc?

    Laptop fell off counter, broke edge of cd...how can I get just the replacement cd?
Results 1 to 25 of 28
Page 1 of 2 1 2