need help please rough idle

Ok so I just upgraded to a tvs2300 from a 112 Maggie been on truck for about two weeks since then I have a very unstable idle. by using the bi directional controls in the scanner I can make it run smooth by commanding a 12.0 AFR at idle im thinking I have a vacuum leak but I would think I would see that in my fuel trims but they seem to be equal. I don't know what to do other then pull off blower and change gaskets. Cam is very mild so I know it shouldn't be this hard to dial in. PLEASE look over my tune and tell me if Im missing something in the tune.

motor seems like it runs the best when I command 11.5, moving timing around does not seem to change anything. My map reading goes from 36 at 14.7 to 33 at 11.5. I have tried spaying around lower intake on blower but I haven't found any change in engine while spraying. Any thoughts?

made a log going to work this morning ''6 miles'' truck also does not start good on the first start of the day or it has to sit about 8 hours. I must overlooking something but I cant figure this out.

whats your injectors?

the injectors are what comes with the blower 42lb marine injectors.

I did another log going home from work. I noticed that when I first start the log the trims were very negative then as I drove they leaned out some, is this due to slow, old o2s 78000 miles or is it the headers and o2 placement. I have searched for any adjustments that need to be made to the o2 tables to correct for the further away placement in the exhaust.What I would like someone to tell me is by looking at these logs does it look like I have a vacuum leak?