Passkey 3 VTD Override

Printable View

10-11-2014
Reddog

Passkey 3 VTD Override

Hi
Im new to this HPtuner. I ordered today the VCM Suite today
I am hoping that the VCM suite will let me over ride the Passkey 3 system. I am pulling a P1631 code with my Scan xl scanner and it also says my fuel disable is active.
Has any one successfully disabled Passkey3 with the HPtuner suite
My truck is stuck and will turn over , fire 1 second and stop
10-11-2014
CatnipG5Bandit

What year truck? Also post your tune and We'll look at it.
10-11-2014
Reddog

Its a 2003 silverado with a 4.8 engine. I don't have my HPtuner yet . I just ordered it today in the hopes that it will disable the VATS
I changed the motor, Had a used PCM reflashed to the VIN and when I went to restart it went into the theft deterrent mode. I have tried the relearn procedure 20 times to no avail. I would rather spend the money on a tuning sysytem then take it to a shop to figure out this VATS system. After all the work to change the motor and not even getting it to run for a second is a big disappointment. I have spark to the plugs and fuel to the rail. Thanks for the reply.
10-11-2014
Montecarlodrag

Yes you will be able to completely disable it.
However, the security light will keep flashing on the cluster. The engine will run without issues but the light will not go away
10-11-2014
CatnipG5Bandit

Cool. When you get it, go to OS then disable the VATS that way. Then do a write entire. It'll make sense when you play with the program. Also download the program from your account page on HPT, don't bother with the CD. IIRC all you need the CD for is the drivers, and you may not even need it for that. If you have any problems contact support immediately.

Quote:

Originally Posted by Montecarlodrag

Yes you will be able to completely disable it.
However, the security light will keep flashing on the cluster. The engine will run without issues but the light will not go away

And you can probably unplug the bulb if it bothers you too much.
10-11-2014
Reddog

Quote:

Originally Posted by CatnipG5Bandit

Cool. When you get it, go to OS then disable the VATS that way. Then do a write entire. It'll make sense when you play with the program. Also download the program from your account page on HPT, don't bother with the CD. IIRC all you need the CD for is the drivers, and you may not even need it for that. If you have any problems contact support immediately.

And you can probably unplug the bulb if it bothers you too much.

Thanks for the re assurance. I can't wait for my VCM and get this baby going.
10-13-2014
camaroguy28

I am new to tuning also and I did this same thing on my 1999 suburban with the vortec 350. It worked like a charm and the light goes off after a while, but it will come back on every once in a while. Like stated above you could pull the bulb out most likely if the light bothers you too much.