T43 - TCC Adapts - Strange Behaviour

Hi All,

For some strange reason, once I enabled TCC adapts on my 6L50 / T43 controller, at steady state driving, Speed, Torque, TPS all steady, I see the TCC pressure just constantly increasing.

Any idea whats going on here? I was under the impression that the TCC Adapts are meant to lower the TCC pressure until it detects slip above what is set in the slip tables (in this case 0) and then increase just a little to hold that slip rate.

I've attached my log, my tune and also a screenshot where you can see the TCC Desired Pressure just keeps increasing.

Attachment 144775

Attachment 144776

Attachment 144777