-
fuel sender
I have a 02 Silverado and just recently installed a 20 gallon fuel cell in it with a 90ohm sender unit. From what I read, the factory sender unit is a 250ohm setup.
Is it possible to change the settings with HPtuners so that my fuel gauge will register properly? If so, how would I go about doing that?
Any suggestions are greatly appreciated!
-
-
Most likely you will need the correct ohms. Not absolutely sure though.
However, you can log the fuel gauge stuff while you add a gallon at a time (or whatever) to fit a corrected curve.
-
Did you ever figure it out? Im using a 15 gallon tank with the 90ohm sender. Any help is appreciated.
-
Have not been able to find anything on this either. 2000 fbody gauge with a 0-50 ohm sending unit in the fuel cell. Anyone have suggestions or know anything about this?
-
Anyone? If not then I will attempt. I just didnt wanna F*&^ anything up.
-
Anyone have any results?
I am debating on a fuel cell right now from aeromotive, which has a 0-90 ohm sender.