Question about MAP readings in scanner

Printable View

10-14-2008
firehawk037

Question about MAP readings in scanner

So I finally got around to starting to play with my HP tunners and trying to log some runs. I will be going to the track this weekend and would like to log my runs. little back ground. I have a procharged 347 01 Trans am firehawk. It currently has a 2 bar tune in it and a MAP sensor from a SS cobalt. When I was logging data in my scanner it shows my MAP maxing out at 105 kpa I would like to see what this is actually reading so I can calculate my actual boost. Is there something I need to change or what. Thanks in advance.

Dan
10-19-2008
FBodyBodhi

You can change the units used in the chart display from kPa to psi by "right clicking" on the chart display window and selecting "chart configuration".

By default I believe the MAP is under the "Chart 2" tree view selection. Just change the Units to psi in the drop down menu.

Hope this helps.
10-20-2008
Bill@HPTuners

Quote:

Originally Posted by firehawk037

So I finally got around to starting to play with my HP tunners and trying to log some runs. I will be going to the track this weekend and would like to log my runs. little back ground. I have a procharged 347 01 Trans am firehawk. It currently has a 2 bar tune in it and a MAP sensor from a SS cobalt. When I was logging data in my scanner it shows my MAP maxing out at 105 kpa I would like to see what this is actually reading so I can calculate my actual boost. Is there something I need to change or what. Thanks in advance.

Dan

If you are running our 2 bar custom operating system simply follow the instructions in the help file to load the 2 bar sensor pid into your table display.
10-20-2008
FBodyBodhi

Wow, I must have had more of a buzz than I thought when I typed that response.

Never drink and type.