Printable View
HELLO, MY GTI 15 CONFIG: STAGE 4 3076R ON E85 ENGINE FORGED.
Would it be possible to have good programming with HP in this setup?
I am also wanting to adjust the tcu dsg for this config. limiting torque to 65kgfm engine and 60kgfm wheel.
The car has around 500hp and runs at 2bar pressure..
I HAVE FULL LOGS HP WITH CURRENT ECU TUNING !!
What's it currently tuned on? Post the logs and can give you an idea of how it's running and if theres room to improve.
I'm going to log the entire 1st to 5th gear and post it. ok
Just a single gear pull, 3rd or 4th. 2500rpm to redline or so would be more helpful most likely
you are running too rich bro, watch out your stft, also that too much inject pw will kill your injectors, try to not exceed 6-7, your on 8 and rich also, lower the pw to get acurate flow to pistons
What do you mean? It's about 0.82-0.85 lambda, not too bad. It appears this car is running DI and MPI, it's the MPI injectors that are running 8+ ms.Quote:
Originally Posted by mo74ji
As for the rest of it... lot of speculation when you can't see the file but, high STFT is probably a wrong value for MPI injector scalar. It looks like this tune massively under reports airmass/torque for the actual given power... the airmass part could very well explain the STFT, and the torque part will cause all sorts of issues for the DQ250 side wrt clamping pressure and general clutch behavior.
I'm guessing this is some sort of commercial OTS tune, but lots of room for improvement IMO.