-
MAF Calibration
I need help with calibrating my new MAF sensor, 06 LQ9, cold air intake, headers, soon to be 80mm turbo, 06 Escalade. I have purchased and installed everything to run the turbo but have yet to figure out what I need to do to calibrate the new MAF. I have sheets from the manufacturer with the HZ and GPS numbers but not quite sure on how to configure them as only some line up with the stock HZ numbers. Any guidance is greatly appreciated.
-
How many match? I would enter what matches, put 0 in for the ones that don't line up, then interpolate between those points.
That ought to get you going so you can tune from there.
-
Thank You, I was trying to adjust the table parameters to match the sheet from manufacturer and was lost. I will do that tonight, again thank you.
-