Page 487 of 831 FirstFirst ... 387437477483484485486487488489490491497537587 ... LastLast
Threads 9721 to 9740 of 16614

Forum: GM V8 Tuning - Engine, Gas (Gen 4)

(2005-2015, LS2, LS7, ...)

  1. Sticky Thread Sticky: Read Me!!! Tuning How-To's & General Information

    Started by Bill@HPTuners, 01-06-2007
    3 Pages •
    1 2 3
    3 Attachment(s)
    • Replies: 40
    • Views: 244,716
    TheMechanic
    06-06-2023 Go to last post

  1. Newbie help - ls3

    Started by sshhh, 11-27-2014
    • Replies: 11
    • Views: 4,580
    PST
    12-02-2014 Go to last post

  2. e67 420hp VS e67 525hp

    Started by sshhh, 12-02-2014
    • Replies: 4
    • Views: 2,151
    sshhh
    12-02-2014 Go to last post

  3. WOT lockup on 6l80e

    Started by cesar, 11-19-2014
    • Replies: 6
    • Views: 4,215
    VodeAn
    12-01-2014 Go to last post

  4. VVT phaser control

    Started by 98 SS, 06-11-2014
    • Replies: 17
    • Views: 6,534
    reddevil96
    12-01-2014 Go to last post

  5. Rich spike, stuble on launch.....look at scan ..help!

    Started by Plaincoupe, 11-23-2014
    • Replies: 5
    • Views: 2,490
    Xjas
    11-30-2014 Go to last post

  6. No Throttle Pedal On 2007 Chevy Silverado

    Started by stanton8980, 02-14-2013
    • Replies: 6
    • Views: 4,210
    TexasGMC08
    11-27-2014 Go to last post

  7. Flashing a used e40 with a different vehicle file a no-go during a write entire

    Started by Tick, 11-25-2014
    3 Attachment(s)
    • Replies: 8
    • Views: 4,351
    schpenxel
    11-27-2014 Go to last post

  8. Anyone have a stock 2006 SSR tune file?

    Started by Tick, 11-25-2014
    1 Attachment(s)
    • Replies: 1
    • Views: 1,497
    2xLS1
    11-26-2014 Go to last post

  9. 5th Gen Camaro, idles fine... then makes itself surge worse and worse?

    Started by GrannySShifting, 11-24-2014
    3 Attachment(s)
    • Replies: 6
    • Views: 3,349
    Xjas
    11-26-2014 Go to last post

  10. HELP! Throttle blip issue...settling back to idle

    Started by kjlindgr, 11-23-2014
    4 Attachment(s)
    • Replies: 4
    • Views: 4,540
    C5 2000
    11-25-2014 Go to last post

  11. p0106 and p0300 after 6.2 swap 4l60e 2013 silverado help!!!

    Started by JoseCAstillo, 11-24-2014
    • Replies: 0
    • Views: 1,409
    JoseCAstillo
    11-24-2014 Go to last post

  12. what is the minimum voltage to start a ls3

    Started by tybob, 11-24-2014
    • Replies: 0
    • Views: 1,077
    tybob
    11-24-2014 Go to last post

  13. Remove FPCM and use normal fuel pump control with an E67

    Started by MikeOD, 11-23-2014
    2 Attachment(s)
    • Replies: 7
    • Views: 8,998
    MikeOD
    11-24-2014 Go to last post

  14. Lambda Error only showing connected to vehicle ?

    Started by GMADDICT, 11-23-2014
    • Replies: 0
    • Views: 1,204
    GMADDICT
    11-23-2014 Go to last post

  15. Stock vz thunder ute l98 6spd

    Started by THE CHAD, 11-23-2014
    • Replies: 0
    • Views: 1,075
    THE CHAD
    11-23-2014 Go to last post

  16. Another File OS ID does not match VCM OS ID.

    Started by Nastruck, 11-20-2014
    • Replies: 6
    • Views: 2,925
    Nastruck
    11-21-2014 Go to last post

  17. need help to make a crank sensor syncro ls3 and rev limiter

    Started by tybob, 11-20-2014
    2 Attachment(s)
    • Replies: 2
    • Views: 1,588
    tybob
    11-21-2014 Go to last post

  18. Good afternoon im new to tuning can you guys check out my tune 2011 silverado 4.8l

    Started by mstradley, 11-19-2014
    3 Attachment(s)
    • Replies: 8
    • Views: 3,371
    mstradley
    11-20-2014 Go to last post

  19. Feul cut-off

    Started by [email protected], 11-16-2014
    1 Attachment(s)
    • Replies: 2
    • Views: 1,667
    [email protected]
    11-20-2014 Go to last post

  20. L92 dont starts

    Started by Gonzalo Bravo, 11-15-2014
    3 Attachment(s)
    • Replies: 10
    • Views: 5,734
    Gonzalo Bravo
    11-19-2014 Go to last post
Page 487 of 831 FirstFirst ... 387437477483484485486487488489490491497537587 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.