Page 359 of 831 FirstFirst ... 259309349355356357358359360361362363369409459 ... LastLast
Threads 7161 to 7180 of 16613

Forum: GM V8 Tuning - Engine, Gas (Gen 4)

(2005-2015, LS2, LS7, ...)

  1. Sticky Thread Sticky: Read Me!!! Tuning How-To's & General Information

    Started by Bill@HPTuners, 01-06-2007
    3 Pages •
    1 2 3
    3 Attachment(s)
    • Replies: 40
    • Views: 243,657
    TheMechanic
    06-06-2023 Go to last post

  1. Boost Enrich not changing commanded EQ

    Started by NJ_Phil, 04-30-2017
    2 Attachment(s)
    • Replies: 4
    • Views: 1,967
    LSxpwrdZ
    05-01-2017 Go to last post

  2. Engine torque management question (table definitions)

    Started by Niemer, 04-30-2017
    1 Attachment(s)
    • Replies: 0
    • Views: 739
    Niemer
    04-30-2017 Go to last post

  3. Can we discuss transients.... response time etc.

    Started by BigDaddyCool, 04-29-2017
    • Replies: 0
    • Views: 729
    BigDaddyCool
    04-29-2017 Go to last post

  4. Timing table resolution scaling for ID2000 05 Vette

    Started by FastBlackTA, 04-28-2017
    • Replies: 1
    • Views: 1,279
    mcfarlnd
    04-29-2017 Go to last post

  5. tip in lean spike

    Started by russ472, 04-29-2017
    1 Attachment(s)
    • Replies: 0
    • Views: 776
    russ472
    04-29-2017 Go to last post

  6. Take a look at these scans

    Started by Jonblarc7, 04-28-2017
    3 Attachment(s)
    • Replies: 4
    • Views: 1,471
    Jonblarc7
    04-28-2017 Go to last post

  7. MAF stack on 9000hz @ wot

    Started by steve-0, 04-27-2017
    1 Attachment(s)
    • Replies: 4
    • Views: 1,881
    steve-0
    04-28-2017 Go to last post

  8. Will be buying HPT soon, Camaro ZL1 bad tuner.....

    Started by Vicster, 12-03-2015
    7 Pages •
    1 2 3 ... 7
    49 Attachment(s)
    • Replies: 134
    • Views: 47,612
    Vicster
    04-28-2017 Go to last post

  9. loading a 2.24 config into 3.4

    Started by h2.4, 04-28-2017
    • Replies: 0
    • Views: 582
    h2.4
    04-28-2017 Go to last post

  10. Help with a CTSv

    Started by RawRacing, 04-25-2017
    2 Attachment(s)
    • Replies: 2
    • Views: 1,433
    RawRacing
    04-28-2017 Go to last post

  11. Holden HSV GTSR W1 - Stock Tune Anyone?

    Started by BigDaddyCool, 04-27-2017
    • Replies: 0
    • Views: 746
    BigDaddyCool
    04-27-2017 Go to last post

  12. DBC throttle body?

    Started by mrtony, 04-27-2017
    • Replies: 2
    • Views: 1,384
    mrtony
    04-27-2017 Go to last post

  13. Expected gains from a 5.3 2014 Silverado Z71

    Started by MADWHIP, 04-26-2017
    2 Attachment(s)
    • Replies: 3
    • Views: 1,513
    MADWHIP
    04-27-2017 Go to last post

  14. Question on Copying Injector Data - Offset vs. Press vs. IGNV Different

    Started by lxcoupe, 04-26-2017
    2 Attachment(s)
    • Replies: 2
    • Views: 1,530
    mowton
    04-27-2017 Go to last post

  15. Flex fuel idle gets richer as temp increases

    Started by Lakegoat, 04-25-2017
    2 Attachment(s)
    • Replies: 3
    • Views: 1,541
    Lakegoat
    04-27-2017 Go to last post

  16. Can't seem to get rid of surging idle issue - VVE tuning

    Started by adunphy, 01-16-2017
    3 Attachment(s)
    • Replies: 12
    • Views: 7,500
    adunphy
    04-27-2017 Go to last post

  17. Problems with 6l80 on a 2010 sierra.

    Started by 02Ls1, 04-26-2017
    1 Attachment(s)
    • Replies: 7
    • Views: 2,607
    02Ls1
    04-27-2017 Go to last post

  18. Basic question, would a 1x cam gear even fire on a 58x motor?

    Started by lxcoupe, 04-26-2017
    • Replies: 2
    • Views: 1,198
    lxcoupe
    04-26-2017 Go to last post

  19. 10 suburban gearing/speedo

    Started by John B, 04-26-2017
    • Replies: 3
    • Views: 1,364
    johnny_boii
    04-26-2017 Go to last post

  20. LC9 Swap Into Colorado (ex-4cyl), Runs great but lopes and 10mph

    Started by lxcoupe, 04-25-2017
    1 Attachment(s)
    • Replies: 0
    • Views: 914
    lxcoupe
    04-25-2017 Go to last post
Page 359 of 831 FirstFirst ... 259309349355356357358359360361362363369409459 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.