Page 727 of 1241 FirstFirst ... 2276276777177237247257267277287297307317377778271227 ... LastLast
Threads 14521 to 14540 of 24804

Forum: GM V8 Tuning - Engine, Gas (Gen 3)

(1997-2009, LS1, LS6, ...)

  1. Sticky Thread Sticky: If you want us to help with a tune or scan issue post your .hpt file, log & .cfg too.

    Started by jimmyblue, 10-19-2009
    92 Attachment(s)
    • Replies: 0
    • Views: 108,005
    jimmyblue
    10-19-2009 Go to last post

  2. Sticky Thread Sticky: READ ME!!! General tuning info and how-to's

    Started by WS6FirebirdTA00, 02-07-2006
    • Replies: 0
    • Views: 291,847
    WS6FirebirdTA00
    02-07-2006 Go to last post

  1. Need stock tune for 02 GMC Sierra 5.3 4L60E

    Started by pontisteve, 04-04-2012
    • Replies: 0
    • Views: 1,230
    pontisteve
    04-04-2012 Go to last post

  2. Fuel trims have no effect and very lean!

    Started by Atomic, 04-02-2012
    • Replies: 9
    • Views: 3,042
    Atomic
    04-03-2012 Go to last post

  3. Idle afr

    Started by docter95, 04-03-2012
    • Replies: 1
    • Views: 1,417
    Beatdown Z
    04-03-2012 Go to last post

  4. Rough VE Table

    Started by NBMLS2TA, 03-28-2012
    1 Attachment(s)
    • Replies: 9
    • Views: 4,965
    printmanjackson
    04-03-2012 Go to last post

  5. Camaro ABS Issue

    Started by SixtoTech, 04-03-2012
    • Replies: 0
    • Views: 1,128
    SixtoTech
    04-03-2012 Go to last post

  6. Complete rewrite of Tune ....VCM will not Allow ?

    Started by wantsum411, 04-03-2012
    • Replies: 7
    • Views: 2,953
    wantsum411
    04-03-2012 Go to last post

  7. bog 1600 rpm to 2800 rpm

    Started by Ed39, 04-01-2012
    • Replies: 1
    • Views: 1,508
    Ed39
    04-03-2012 Go to last post

  8. trying to write stock tune to 98 trans am but wont let me.

    Started by bigfatls6, 04-02-2012
    • Replies: 3
    • Views: 2,006
    Asylumwarp
    04-03-2012 Go to last post

  9. 2006 silverado 2 bar REP mode issue, input please

    Started by cpr-performance, 04-02-2012
    • Replies: 2
    • Views: 1,840
    cpr-performance
    04-02-2012 Go to last post

  10. launch control with hptunner

    Started by seb28, 06-16-2010
    2 Pages •
    1 2
    • Replies: 29
    • Views: 27,631
    hobbesnmina2001
    04-02-2012 Go to last post

  11. 98 PCM/wire harness swap, so I can run 3bar!

    Started by burken01, 03-28-2012
    • Replies: 2
    • Views: 2,222
    Montecarlodrag
    04-02-2012 Go to last post

  12. Need help with tuning:)

    Started by goa2head, 04-02-2012
    • Replies: 2
    • Views: 1,626
    98Camarod
    04-02-2012 Go to last post

  13. 2003 408 Whipple 2.9 Escalade Help

    Started by pganci, 03-28-2012
    • Replies: 7
    • Views: 3,413
    pganci
    04-02-2012 Go to last post

  14. how do you pull timing for nitrous using the IAT spark table and IAT sensor?

    Started by bigfatls6, 03-29-2012
    • Replies: 4
    • Views: 3,532
    RubenTX
    04-02-2012 Go to last post

  15. New PCM, won't start after security relearn

    Started by Atomic, 04-01-2012
    • Replies: 1
    • Views: 2,019
    Atomic
    04-01-2012 Go to last post

  16. bank 2 STFT acting lazy?

    Started by SIXXER, 03-31-2012
    • Replies: 1
    • Views: 1,402
    SIXXER
    04-01-2012 Go to last post

  17. Please help me not feel so bad about my over priced tune.

    Started by mrjpsmitty, 03-31-2012
    • Replies: 4
    • Views: 2,285
    mrjpsmitty
    04-01-2012 Go to last post

  18. 06 and 07classic silverado pcm...

    Started by cpr-performance, 12-23-2011
    • Replies: 3
    • Views: 2,197
    cpr-performance
    04-01-2012 Go to last post

  19. Strange Idle Problem (SD Tune)

    Started by Chrisrokc, 03-30-2012
    • Replies: 5
    • Views: 2,614
    Chrisrokc
    04-01-2012 Go to last post

  20. question about tuning mass air. Do I adjust open loop fa vs coolant temp vs map?

    Started by bigfatls6, 03-31-2012
    • Replies: 2
    • Views: 1,913
    NBMLS2TA
    03-31-2012 Go to last post
Page 727 of 1241 FirstFirst ... 2276276777177237247257267277287297307317377778271227 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.