Page 1002 of 1240 FirstFirst ... 25029029529929989991000100110021003100410051006101210521102 ... LastLast
Threads 20021 to 20040 of 24799

Forum: GM V8 Tuning - Engine, Gas (Gen 3)

(1997-2009, LS1, LS6, ...)

  1. Sticky Thread Sticky: If you want us to help with a tune or scan issue post your .hpt file, log & .cfg too.

    Started by jimmyblue, 10-19-2009
    92 Attachment(s)
    • Replies: 0
    • Views: 107,718
    jimmyblue
    10-19-2009 Go to last post

  2. Sticky Thread Sticky: READ ME!!! General tuning info and how-to's

    Started by WS6FirebirdTA00, 02-07-2006
    • Replies: 0
    • Views: 291,524
    WS6FirebirdTA00
    02-07-2006 Go to last post

  1. Just a quick question

    Started by RZRSEDGE, 05-28-2008
    • Replies: 2
    • Views: 1,678
    RZRSEDGE
    05-28-2008 Go to last post

  2. Controlling PE on 98?

    Started by crewchef, 05-27-2008
    • Replies: 11
    • Views: 5,013
    Bill@HPTuners
    05-28-2008 Go to last post

  3. Can someone do a 4l80e segment swap for me?

    Started by AidanN20, 05-27-2008
    • Replies: 2
    • Views: 1,649
    EC_Tune
    05-28-2008 Go to last post

  4. Confused Noob?

    Started by Legend802, 05-25-2008
    • Replies: 3
    • Views: 1,914
    Legend802
    05-27-2008 Go to last post

  5. Need 2006 SS Silverado Factory File

    Started by RWTD, 05-27-2008
    • Replies: 1
    • Views: 1,398
    RWTD
    05-27-2008 Go to last post

  6. Going WOT the Status Bit Doesn't Show Open Loop???

    Started by bseitz, 05-26-2008
    • Replies: 4
    • Views: 2,678
    bseitz
    05-27-2008 Go to last post

  7. Tapping map sensor for Meth controller???

    Started by Dozer, 05-26-2008
    • Replies: 0
    • Views: 1,249
    Dozer
    05-26-2008 Go to last post

  8. Running Rich, Wont Idle-P0101 ( New Cam )

    Started by TXZ0603, 05-24-2008
    • Replies: 7
    • Views: 5,511
    LinearX
    05-26-2008 Go to last post

  9. Strange stutter/fall, logs attached

    Started by 1st-BAD-LS1, 04-30-2008
    • Replies: 12
    • Views: 4,328
    1st-BAD-LS1
    05-26-2008 Go to last post

  10. Going rich around 4000rpms

    Started by HPJunkie, 05-23-2008
    • Replies: 3
    • Views: 1,754
    muayyadf1
    05-24-2008 Go to last post

  11. Whats the cause of low cylinder air mass?

    Started by 01WS6, 05-04-2008
    3 Pages •
    1 2 3
    • Replies: 50
    • Views: 22,603
    WS6FirebirdTA00
    05-23-2008 Go to last post

  12. WOT Shift Points Problems

    Started by bigboykilroy, 05-19-2008
    • Replies: 8
    • Views: 3,815
    bigboykilroy
    05-23-2008 Go to last post

  13. 16 Injectors - LS1 PCM

    Started by Doubledip, 05-12-2008
    • Replies: 9
    • Views: 4,988
    Doubledip
    05-22-2008 Go to last post

  14. 03 Chevy 6.0 will not enter PE?!

    Started by 01 MidMet WS6, 05-21-2008
    • Replies: 10
    • Views: 3,899
    01 MidMet WS6
    05-22-2008 Go to last post

  15. How to take my tune to the next level?

    Started by pHEnomIC, 05-17-2008
    • Replies: 1
    • Views: 1,619
    MonkeyGod
    05-22-2008 Go to last post

  16. Can tune with no VSS in a m6 swapped to th400?

    Started by Frost, 05-19-2008
    • Replies: 4
    • Views: 2,613
    Frost
    05-22-2008 Go to last post

  17. reduce engine power?

    Started by flaco, 05-19-2008
    • Replies: 5
    • Views: 2,820
    WS6FirebirdTA00
    05-22-2008 Go to last post

  18. 04 Silverado SS

    Started by Rex, 05-21-2008
    • Replies: 1
    • Views: 1,940
    popeye55
    05-21-2008 Go to last post

  19. LC1 Wideband Sensor in the B1S1 Location, now getting constant 1133 Codes....Help!

    Started by bseitz, 05-20-2008
    • Replies: 4
    • Views: 2,616
    bseitz
    05-21-2008 Go to last post

  20. VE table error, what is considered "good"

    Started by radkon, 05-19-2008
    • Replies: 8
    • Views: 4,021
    radkon
    05-20-2008 Go to last post
Page 1002 of 1240 FirstFirst ... 25029029529929989991000100110021003100410051006101210521102 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.