Register
Help
Remember Me?
What's New?
Activity Stream
New Posts
New Events
Mark Forums Read
Forum
Advanced Search
Home
Activity Stream
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
3 Minutes Ago
Virtue
replied to a thread
LS6 stroked and boosted new build. Huge coughing/studdering at 0 vac on acceleration
in
GM V8 Tuning - Engine, Gas (Gen 3)
Come to think of it, my knock sensors should be engaging with this amount of coughing... Hmmm....
see more
11 replies | 95 view(s)
6 Minutes Ago
Virtue
replied to a thread
LS6 stroked and boosted new build. Huge coughing/studdering at 0 vac on acceleration
in
GM V8 Tuning - Engine, Gas (Gen 3)
It was the resolution I was thinking about also. And the original tuner was thinking it would hit 19lbs, but, that was a guess. I have belt slip at...
see more
11 replies | 95 view(s)
11 Minutes Ago
Alvin
replied to a thread
L86 Limp mode then stall, won't restart
in
GM V8 Tuning - Engine, Gas (Gen 5)
Heads up your attachments failed.
see more
1 replies | 35 view(s)
13 Minutes Ago
Alvin
replied to a thread
Startup File
in
GM V8 Tuning - Engine, Gas (Gen 5)
The canned tunes from those companies are usually not super great. BTW. You should read about adding a SCIAP sensor. It makes an absolute...
see more
1 replies | 68 view(s)
14 Minutes Ago
Alvin
replied to a thread
gen 3 torque management
in
GM V8 Tuning - Engine, Gas (Gen 3)
It's possible that timing changed between shifts before but its almost certainly not TM. No GEN 3 I'm aware of has torque management between manual...
see more
4 replies | 114 view(s)
17 Minutes Ago
Alvin
replied to a thread
LS6 stroked and boosted new build. Huge coughing/studdering at 0 vac on acceleration
in
GM V8 Tuning - Engine, Gas (Gen 3)
That is a good question. You can use any map sensor with any OS. You do loose quite a bit of resolution on these with a 3 bar OS. Considering...
see more
11 replies | 95 view(s)
20 Minutes Ago
Alvin
replied to a thread
dakota digital speed sensor caliibration
in
GM V8 Tuning - Engine, Gas (Gen 3)
It doesn't matter if the speedo is accurate in the scanner/ECM unless you are using that to drive a speedometer. Often the sending units for...
see more
4 replies | 85 view(s)
20 Minutes Ago
Virtue
replied to a thread
LS6 stroked and boosted new build. Huge coughing/studdering at 0 vac on acceleration
in
GM V8 Tuning - Engine, Gas (Gen 3)
Thanks Alvin. Ok. So, question here. Knowing the limitations of my P59 ECM, would you go with a 3 bar from GM or a 2 bar GM. I do have a GM 2bar...
see more
11 replies | 95 view(s)
21 Minutes Ago
Nbswar
replied to a thread
2015 Challenger srt 392 stock tune
in
Dodge Tuning - Engine, Gas
Thank you
see more
2 replies | 21 view(s)
23 Minutes Ago
Alvin
replied to a thread
68 Chevy C-10
in
GM V8 Tuning - Engine, Gas (Gen 3)
i'll bet the return from the regulator is blocked or the regulator is hooked up wrong.
see more
6 replies | 97 view(s)
26 Minutes Ago
Virtue
replied to a thread
LS6 stroked and boosted new build. Huge coughing/studdering at 0 vac on acceleration
in
GM V8 Tuning - Engine, Gas (Gen 3)
Sorry, I didn't understand what you meant. I thought you are telling me to get a tune... Here's my tune.
see more
11 replies | 95 view(s)
27 Minutes Ago
Alvin
replied to a thread
LS6 stroked and boosted new build. Huge coughing/studdering at 0 vac on acceleration
in
GM V8 Tuning - Engine, Gas (Gen 3)
I would only use GM map sensors on this. There are plenty of options. The aftermarket ones I've had serious issues with. There is a turbo...
see more
11 replies | 95 view(s)
30 Minutes Ago
Alvin
replied to a thread
LS6 stroked and boosted new build. Huge coughing/studdering at 0 vac on acceleration
in
GM V8 Tuning - Engine, Gas (Gen 3)
You really ought to delete the map sensor pid you are using and add "2/3 bar map" in the scanner. I'm assuming this has a 2/3 bar OS on it. If it...
see more
11 replies | 95 view(s)
33 Minutes Ago
edcmat-l1
replied to a thread
help with not idling after stop when coming down from 40mph or higher
in
GM V8 Tuning - Engine, Gas (Gen 3)
You have something going on with bank 1. It has the fuel trims pegged at +50%. Need to check the header temps with a temp gun. Might have multiple...
see more
9 replies | 113 view(s)
36 Minutes Ago
Alvin
replied to a thread
help with not idling after stop when coming down from 40mph or higher
in
GM V8 Tuning - Engine, Gas (Gen 3)
You won't hurt this setup being too lean. The drivers side o2 sensor looks suspect. The fueling needs to be gone over.
see more
9 replies | 113 view(s)
38 Minutes Ago
Alvin
replied to a thread
Idle surging and drivability help needed.
in
GM V8 Tuning - Engine, Gas (Gen 3)
There is a lot of rough things in that tune. I'd consider starting from scratch. You should be able to find a stock compare file on the repository.
see more
3 replies | 65 view(s)
52 Minutes Ago
allpargarage
replied to a thread
2015 Challenger srt 392 stock tune
in
Dodge Tuning - Engine, Gas
Here goes read from 2015 Challenger
see more
2 replies | 21 view(s)
57 Minutes Ago
edcmat-l1
replied to a thread
Idle surging and drivability help needed.
in
GM V8 Tuning - Engine, Gas (Gen 3)
Need to post a complete list of mods so we know what we're dealing with. Don't know if this is a stock vehicle with a cold air intake or turbo with...
see more
3 replies | 65 view(s)
1 Hour Ago
[email protected]
replied to a thread
help with not idling after stop when coming down from 40mph or higher
in
GM V8 Tuning - Engine, Gas (Gen 3)
Tune and file posted sir
see more
9 replies | 113 view(s)
1 Hour Ago
[email protected]
replied to a thread
help with not idling after stop when coming down from 40mph or higher
in
GM V8 Tuning - Engine, Gas (Gen 3)
Tune posted sir
see more
9 replies | 113 view(s)
1 Hour Ago
juniiorbraga94
started a thread
Gti 15 stage 4 forged 3076r on e85
in
Audi/VW
HELLO, MY GTI 15 CONFIG: STAGE 4 3076R ON E85 ENGINE FORGED. Would it be possible to have good programming with HP in this setup? I am also...
see more
0 replies | 13 view(s)
1 Hour Ago
Boogieman55
started a thread
4L80E swap in Hummer H2
in
GM V8 Tuning - Engine, Gas (Gen 3)
4L80e Swap in Hummer H2 TCC problem. Hi, I did transmission swap in my H2. Everything working just fine, no trouble codes but when oil reaches 185...
see more
0 replies | 15 view(s)
1 Hour Ago
[email protected]
replied to a thread
help with not idling after stop when coming down from 40mph or higher
in
GM V8 Tuning - Engine, Gas (Gen 3)
its also running very lean to lean to drive dont want to hurt anything i have 52psi fuel pressure which is oem specs any help plz
see more
9 replies | 113 view(s)
1 Hour Ago
TriPinTaZ
replied to a thread
Engine torque management for 8L 90
in
GM V8 Tuning - Transmission
There is a toggle in the TCM along with some torque settings in the TCM and ECU
see more
1 replies | 60 view(s)
2 Hours Ago
engineermike
replied to a thread
Possible? Ignition cut while shifting automatic gearbox like 8hp
in
Ford Tuning - Engine, Gas (Non Ecoboost, US)
You basically have to force the SAI system to skip S and A and go straight to I. To do this, you'd have to set Trans Tq Trunc to 1.0 in table 33458...
see more
3 replies | 46 view(s)
2 Hours Ago
engineermike
replied to a thread
Shelby GT500 RPM limiters
in
Ford Tuning - Engine, Gas (Non Ecoboost, US)
I dunno man, you didn't list the shift points in the first post in the list of tables that you adjusted. I opened the file and all the shift points...
see more
6 replies | 207 view(s)
2 Hours Ago
Nbswar
started a thread
2015 Challenger srt 392 stock tune
in
Dodge Tuning - Engine, Gas
Does anyone happen to have the stock file for a 2015 challenger srt 392 auto? I searched the repository and only found one. The original owner of...
see more
2 replies | 21 view(s)
2 Hours Ago
melition
replied to a thread
gen 3 torque management
in
GM V8 Tuning - Engine, Gas (Gen 3)
So you just replied to insult someone's intelligence and weren't actually interested in the log and tune or being helpful in the first place right? ...
see more
4 replies | 114 view(s)
3 Hours Ago
bsaathoff73
replied to a thread
Lost injector info
in
GM V8 Tuning - Engine, Gas (Gen 3)
Im 50 years old. I was raised to respect others and my neighbors. To help others in times of need. Yes. I do appreciate it. I just dont post it...
see more
52 replies | 1202 view(s)
3 Hours Ago
loskani
replied to a thread
Possible? Ignition cut while shifting automatic gearbox like 8hp
in
Ford Tuning - Engine, Gas (Non Ecoboost, US)
Min Spark Tq Ratio ?
see more
3 replies | 46 view(s)
More Activity
No More Results
No Recent Activity